User Manual

Source Gain Settings

The Source Gain setting allows you to increase the volume of each audio source so that all

sources are at the same relative volume.

To change the source gain setting, press the + button to increase the volume of the respective

source and press the – button to decrease the volume of the respective source. These settings

are system-wide and affect all zones.

After modifying the source gain for all eight sources, press and release the src button to

advance to the IR Passthrough setting.

IR Passthrough

The IR Passthrough setting allows you to select whether IR signals from a remote control are

routed to the connected audio source. When enabled, this allows you to remotely control a

connected audio source from the respective VSC.

To change the IR Passthrough setting, press the + button to enable IR passthrough and press

the – button to disable IR passthrough. This setting must be performed at the VSC in each

audio zone and is applicable to that particular zone.

After modifying the IR Passthrough setting, press and release the src button to advance to the

IR Passthrough setting.

The IR setting allows you to set whether the IR signals received at the VSC are sent to the

Hi-Fi

2 for processing. When enabled, the VSC will route IR signals to the Hi-Fi 2 processor

whenever an IR signal is received at the respective VSC.

To change the IR setting, press the + button to enable IR and press the – button to disable IR.

This setting must be performed at the VSC in each audio zone and is applicable to that

particular zone.

After modifying the IR setting, press and release the src button to exit the menu. The display

will revert back to the source setting.

WEB VERSION