Specification

PRODUCT DATA
PE200-1/PE200-7 Power Extenders
PE200-1/PE200-7 Power Extenders
DESCRIPTION
The Leviton PE200-1 Power Extenders allow a
dimming zone’s power handling capacity to be
extended to a full 1920W/VA on 120V input
power. The PE200-1 drives 120V Advance Mark
10™ or equivalent dimmable fluorescent ballasts
only.
The PE200-7 allows a dimming zone’s power
handling capacity to be extended to a full
3000VA on 77V input power. The PE200-7
drives 277V Advance Mark 10™ or equivalent
dimmable fluorescent ballasts.
FEATURES
• Works with Mark 10 or Hi-Lume
®
120V
- PE200-1, 277V
- PE200-7, dimmable ballasts
• Low-end trim available for setting the minimum
brightness level
• Emulates the characteristics of the dimmer
that it is connected to for dimming range and
resolution
• Works with any Dimensions
®
Multi-Zone
Controller/Dimmer when zone is set-up as a
fluorescent dimmer to extend load capacity on
any zone
Note: Zone must be set-up for incandescent load for Hi-Lume
ballasts. Mark 10 is a trademark of the Advance Transformer
Company. Hi-Lume is a registered trademark of Lutron Electronic
Co., Inc.
MOUNTING
All Power Extenders must have 4-1/2”
spacing above and below each unit for
proper ventilation and heat dissipation (refer
to figure 3). Line voltage wiring should be
at least 6ft away from sound or electronic
equipment wiring. Mount Power Extender
to wallbox with TOP facing up as follows: For
wallbox mounting (refer to figure 1), for flush
mounting (refer to figure 2) and for panel
mounting (not shown), proceed as follows:
• The enclosure must be in accordance with
all local and national electrical codes
• Leviton does not recommend using a door
to enclose the front of a panel, this
restricts airflow to the controls
• If mounting multiple controls in an
enclosure:
- Ambient temperature within an enclosure
must remain between 32-104
o
F (0-40
o
C).
- If not mounting in a metal enclosure, all
units must be mounted in a wall box.
• To improve heat dissipation of controls,
remove the faceplate from the unit
1900 Box
Power
Extender
TOP
2 Gang Raised Cover
1900 Box
Raised Cover
Mounting Screws
(4 Paces)
T
O
P
2 Gang Raised Cover
TOP
TOP
4-1/2" (111.4mm)
Minimum
4-1/2" (111.4mm)
Minimum
Figure 1: Surface Mounting
Figure 2: Flush Mounting
Figure 3: Front View Spacing
Power
Extender
Wallplate
Raised Cover
Mounting Screws
(4 Paces)
Power
Extender
Power
Extender
Wallplate
Leviton Manufacturing Co., Inc. Energy Management, Controls and Automation
20497 SW Teton Avenue, Tualatin, OR 97062 tech line 800-959-6004 fax [phone]
© 2015 Leviton Manufacturing Co., Inc. All rights reserved. Subject to change without notice.