Use and Care Manual

10
You can set a timer for 1–12 hours.
1. Tap . The display will switch from
showing the PM2.5 reading to the time
you’ve selected.
2. Tap repeatedly to select a time in
1-hour increments. If you don’t touch any
buttons for 5 seconds, the display will
switch to showing the PM2.5 reading and
the timer will start automatically.
Note:
• While a timer is active, tapping will
show the remaining time, rounded up to
the nearest hour. Tap again within
5 seconds to add more time in 1-hour
increments.
• You can see the exact remaining time in
the VeSync app.
Note:
• You can change the fan speed at any
time while the timer is on.
• The timer will restart if the time is
changed.
• The air purifier will remember the last
timer setting while turned o, but the
timer will be cancelled and need to be
restarted.
• You can set a timer for 1–24 hours in
the VeSync app.
3. The timer will count down from your
selected time.
Note: Press and hold for 2 seconds to
cycle through timer options automatically in
1-hour increments.
USING YOUR PURIFIER (CONT.)
Timer
4. When the timer is finished, the air purifier
will turn o.
5. To cancel a timer, tap repeatedly until
the display reads “--H”.
When the air purifier is on, you can lock
the display to prevent settings from being
accidentally changed. Buttons will not
respond to being tapped.
1. Press and hold for 3 seconds to lock
the display. The indicator will light up
in the center of the display.
This turns o the display lights on the air
purifier, including button lights and indicator
lights (except the Check Filter Indicator).
1. Tap to turn o the display.
2. Tap any button (except or ) to
temporarily turn the display back on. If
you don’t tap another button, the display
will turn back o after 3 seconds.
3. Tap to turn the display back on. The
display will stay on.
Note: The Check Filter Indicator will still turn
on and stay on if it’s time to check your filter
(see page 15).
Note: If the display is turned o, the
indicator will flash 3 times to show that the
display has been locked, then turn o.
Note:
• If the display is turned o, the
indicator will flash 3 times to show that
the display has been unlocked.
• Display Lock can still be used when the
air purifier is in Standby Mode.
Display Off
Display Lock
2. The indicator will blink when any
other button is tapped to indicate that
Display Lock is on.
3. Tap and hold again for 3 seconds to
unlock the display. The indicator will
turn o.