Installation Guide

33
ENGLISH
Cycle Settings And Options (cont.)
Damp Dry Signal
With this option, the dryer will signal when the load
is approximately 80% dry. This allows you to remove
faster- drying lightweight items or items that you would
like to iron or hang while still slightly damp. Press the
Damp Dry Signal button to activate or deactivate Damp
Dry Signal.
Wrinkle Care
Selecting this option will tumble the load periodically for
up to 3 hours after the selected cycle, or until the door is
opened. This is helpful in preventing wrinkles when you
are unable to remove items from the dryer immediately.
Special Functions
The option buttons also activate special functions,
including Child Lock. Press and hold the Child Lock
button marked with the special function.
* Child Lock
Use this option to prevent unwanted use of the dryer
or to keep cycle settings from being changed while the
dryer is operating. Press and hold the Damp Dry Signal
button for 3 seconds to activate or deactivate the Child
Lock function.
The Child Lock icon will be shown in the display, and all
controls are disabled except the POWER button.
NOTE
Once set, Child Lock remains active until it is manually
deactivated. Child Lock must be turned off to run
another cycle. To deactivate Child Lock, press and hold
the Damp Dry Signal button for three seconds.
Energy Saver
This option helps to reduce the energy consumption in
the Normal Cycle, depending on the load size.
When the Energy Saver option is selected, the cycle
begins with an air dry section and the drying time is
increased.
NOTE
The Energy Saver option is turned on by default in the
Normal Cycle.
Turn off the Energy Saver option for a faster Normal
cycle which begins with heated drying.
* Default On/Off
This option allows the Energy Saver settings to be
changed.
To run a Normal cycle without the Energy Saver option,
press and hold the Energy Saver button for three
seconds.
ON or OFF appears in the display.
Custom Program
If you have a special combination of settings that you
use frequently, you can save these settings as a Custom
Program..
* To Save a Custom Program:
1. Turn on the dryer and press the Cycle Buttons to select
the desired cycle.
2. Use the cycle setting buttons to adjust the settings for
that cycle.
3. Press the cycle option button(s) for the option you
would like to add.
4. Press and hold the Custom PGM button for 3 seconds.
NOTE
You may save only one custom program at a time.
Pressing and holding the Custom PGM button will
overwrite any previously saved custom program.
To Recall a Custom Program:
1. Turn on the dryer.
2. Press the Custom PGM button.
3. Press the START/PAUSE button to start the cycle.
HOW TO USE
MFL67731056_en_150715.indd 33 2015.7.15 3:39:4 PM