Use and Care Manual

ManualsBrandsLG Electronics ManualsHousehold Appliance9.0 cu. ft. Electric Dryer with Steam in Graphite Steel

OPERATION

Operating the Dryer

TURN ON THE DRYER

Press the POWER button to turn on the dryer. The cycle LEDs illuminate and a

signal sounds, if turned on. Refer to page 12.

BEGIN CYCLE

Press the Hold to Start button to begin the cycle. The cycle can be paused at

any time either by opening the door or by pressing the Hold to Start button. If

the cycle is not restarted within 4 minutes, the dryer will shut off and the cycle

settings will be lost.

SELECT A CYCLE

Turn the cycle selector knob in either direction until the LED for the desired

cycle is on. The preset temperature, dry level, and option settings for that cycle

will be shown. Refer to page 35. Default settings for the selected cycle can now

be changed if desired. This can be done using the cycle modifier buttons as

shown on page 38. Cycle options can be added using the option buttons as

shown on page 38-41.

NOTE

Not all options or modifiers are available on all cycles. A different chime will

sound and the LED will not come on if the selection is not allowed.

LOAD THE DRYER

Load the dryer with the wet laundry from the washer. If the load is extra large,

you may need to divide it into smaller loads for proper performance and fabric

care.

CLEAN THE LINT FILTER

If the lint filter has not already been cleaned, lift out the filter and remove the

lint from the last load. This will help ensure the fastest and most efficient drying

performance.

Lint Filter

OPErATiON

END OF CYCLE

When the cycle is finished, the chime will sound if it is set. Remove your

clothing from the dryer immediately to reduce wrinkling. If WRINKLE CARE

is selected, the dryer will tumble briefly every few minutes to help prevent

wrinkles from setting in the clothes.

MFL67731061_en_160511.indd 34 2016.5.11 10:35:33 AM

Summary of content (8 pages)

PAGE 1
34 OPERATION OPERATION Operating the Dryer CLEAN THE LINT FILTER 1 Lint Filter 2 If the lint filter has not already been cleaned, lift out the filter and remove the lint from the last load. This will help ensure the fastest and most efficient drying performance. LOAD THE DRYER Load the dryer with the wet laundry from the washer. If the load is extra large, you may need to divide it into smaller loads for proper performance and fabric care.
PAGE 2
OPERATION = default setting Cycle Guide Fabric Type Steam SanitaryTM comforters, shirts, trousers (except especially delicate fabrics) comforters, bedding, children’s clothing Anti Bacterial Do not use this cycle with delicate fabrics.
PAGE 3
6 OPERATION Sorting Loads Check the Lint Filter before Every Load Fabric care labels Most articles of clothing feature fabric care labels that include instructions for proper care. To clean, pull the lint filter straight up and roll any lint off the filter with your fingers. Do not rinse or wash the filter to remove lint. Push the lint filter firmly back into place. See Regular Cleaning for more information.
PAGE 4
OPERATION 37 Using the Lid - Push the front handle to slide the lid open. ENGLISH Opening the lid Closing the lid - Pull the top of the handle to slide the lid closed. w WARNING • To avoid injury, do not place fingers under the lid or between the lid and the cabinet when pressing or sliding the top lid open or closed. MFL67731061_en_160511.indd 37 2016.5.
PAGE 5
38 OPERATION Cycle Modifier Buttons SENSOR DRY cycles have preset settings that are selected automatically. MANUAL DRY cycles have default settings, but you may also customize the settings using the cycle modifier buttons. Press the button for that option to view and select other settings. NOTE To protect your garments, not every dryness level, temperature, or option is available with every cycle. See the Cycle Guide for details. DRY LEVEL Selects the level of dryness for the cycle.
PAGE 6
OPERATION 39 Special Functions ENGLISH The option buttons also activate special functions, including CHILD LOCK. Select the option by pressing the option button. Press and hold the option button to select special features marked with the asterisk (*), such as Child Lock. * CHILD LOCK Use this option to prevent unwanted use of the dryer or to keep cycle settings from being changed while the dryer is operating. Press and hold the button for 3 seconds to activate or deactivate the CHILD LOCK function.
PAGE 7
40 OPERATION Custom Program If you have a special combination of settings that you use frequently, you can save these settings as a CUSTOM PROGRAM. To Save a Custom Program: 1. Turn on the dryer and turn the cycle selector knob to select the desired cycle. 2. Use the cycle modifier buttons to adjust the settings for that cycle. 3. Press the cycle option button(s) for the option you would like to add. A confirmation message will be shown in the display. 4.
PAGE 8
OPERATION Steam Functions (cont.) 41 NOTE • Do not open the dryer door during steam cycles. Failure to follow this warning can cause serious injury or death. • Do not touch the steam nozzle in the drum during or after the steam cycle. Failure to follow this warning can cause serious injury or death. ENGLISH wWarning • Steam may not be clearly visible during the steam cycles. This is normal.