User manual

( ) to lower it.
counterclockwise ( ) to raise
38
1. Choose a good location.
Place your fridge-freezer where it is easy
to use.
2. Do not place the appliance close to
sources of heat, exposed to the direct
sunlight or moisture.
4.
6. Please, do not remove the round stickers
on the back side of the refrigerator.
They are performing decoration functions
by closing technological holes.
7. To avoid vibration, the unit must be
leveled. If required, adjust the leveling
screws to compensate unevenness of
the floor. The front should be slightly
higher than the rear for better door closing.
The front should be slightly higher than the
rear to aid in door closing. To easily turn
the leveling screws tilt the appliance
slightly. Turn the leveling screws
forward part of a refrigerator, clockwise
8. Before using the appliance clean it
thoroughly.
9. Install accessories such as ice cube box,
etc., in their proper places. They are
packed together to prevent possible
damage during transportation.
10. Connect the power supply cord (or plug)
to the outlet. Don't plug in with other
appliances on the same outlet.
Installation
When the appliance is installed let it
operate for 2-3 hours at normal temperature
setting before filling it with fresh or frozen
food. After unplugging the appliance, wait
for 5 minutes or longer before reconnecting
the plug. Your fridge-freezer is now ready for
use.
Starting
The appliance is designed to operate at
the limited range of ambient temperature,
depending on climate zones. Do not use
the appliance at the temperature out of the
limit. Climate class of your appliance is
indicated on the label with technical
description inside the fridge compartment.
Climate class
Class
Ambient temperature
range °C
+10 to +32
+16 to +43
+16 to +38
+16 to +32
SN
N
T
ST
Symbol
Extended
temperate
Temperate
Subtropical
Tropical
To provide necessary of air circulation, you
should leave enough space behind, on each
side and top of refrigerator-freezer. Set the
limit stops in the upper corners of the back
plate of the device as shown in picture 1.
Stops are delivered in the basket door inside
the refrigeration cabinet.
5. To provide optimal heat exchange and the
reduction of power consumption, it is
recommended to keep the gap from the top,
between the rear and side walls of the device
and room walls not less than 5 cm.(picture 2)
3. Make sure that the power supply voltage and
type of current which are specified in the
instruction are according to the settings in
your power supply.
INSTALLATION