User manual

13
TO REVERSE THE DOORS (OPTIONAL)
Note:To avoid the two doors dropping and result in physical injure,at least
two persons are required to change the door opening type.
If you need to replace the door opening type because of the room or some other reasons,
please operate as the following steps.
1. Disassemble the Hinge Middle(1);
2. Remove the Refrigerator Door (2) and the Freezer Door (3) (cooperate with another person);
4. Remove the pin of Hinge Upper Right and assemble it on Hinge Upper Left (5);
7. Remove the Cap on the left of the Hinge Middle and install it on the corresponding position
(9) on the right side;
8. Remove the Right limit on the refrigerator door and the Freezer door (10). And install it on the
refrigerator door and the Freezer door.
9. Remove the cap hinge and bush on refrigerator door and Freezer door respectively, assemble
them on the corresponding position on the other side (11).
10. Install Refrigerator door (13) and Freezer door (14) (cooperatewith another person),then fix
the hinge middle on the left side(15).
6.Take out the spare Hinge Lower Left from the material bag and replace it on the corresponding
position. Remove the Pin from the Hinge Lower Right to the Hinge Lower Left (8);
3. Remove the Top Cover (4);
5. Remove the Cap Hinge and install it on the corresponding on the right side (6), install the Top Cover (7);
11
11
12
12
14
15
8
9
5
7
6
13
11
11
NOTE
Reversing the doors is not covered by the warranty.