User manual

bag. Take the right cap out of the alternate bag, then install

Note

Reversing the doors is not covered by the warranty.

32 31

5. Loosen the bolt of the Hinge Middle , remove the

middle hinge , and lift up the freezer door to separate

it.Separate the hinge cover and set it on the separated

part of middle hinge . After unscrewing the screw connected

to the bottom cover connect the cover cap on the right

side. Loosen the pin in counterclockwise direction and

move to the hole on the left side to tighten in clockwise

direction. Loosen the bolt connected to the lower hinge

. Unscrew the screw fixating the door stopper at the

bottom of the freezer door , and fixate it on the hole on

the left side with the door stopper . And then, move t

upper cap to the right and cover it.

2829

6. Set the separate lower hinge on the bottom hole of the

left side of the freezer, and tighten the bolt . After fixating

the bottom cover at the regular position, align the freezer

door on the pin of lower hinge to attach it properly.

Turn over the separated middle hinge and sheet hinge

to assemble them. Tighten the bolt ,than set the washer

on the middle hinge . (When tightening the bolt, be

careful not to cause an scratch on the cap decor on top of

the freezer door).

8. Move the separated door handle to the right and fixate

the screw on the right position to attach the door cap .

Move the door cap on the right side to the left and attach

it. Attach the freezer door handle in the same method as

the refrigerator door handle .

7. After assembling the door by aligning the hinge hole on the

bottom of the refrigerator door and the pin of the middle

hinge , connect properly to the hold of the upper left hinge

included in the alternate bag. Tighten the bolt to screw

the screws to the left hinge cover included in the alternate

it on the right side of the refrigerator top.