User guide

15Installation
Installation
3
Satellite Setting
Once you have completed setting the digital
receiver to your individual preferences, you can
proceed, if necessary, to adjust the unit settings
to your antenna. The menu [Satellite Setting]
contains the satellites that have been selected
in the installation assistant. If the installation
assistant was interrupted, the satellite position
[Astra19.2E] is pre-programmed. Should you
wish to receive other satellites, or if you are
using a dierent type of LNB, you can adjust
your digital receiver to the appropriate data as
follows:.
Antenna Setting
1. Select [Satellite Setting] option in the [DTV]
menu, then press ENTER ( ).
NOTE
If the [DTV Lock] option is set to [Lock], this
function is available when you enter the password
correctly. (page 34).
2. The [Satellite Setting] menu appear on the
screen. Use
U
/
u
to select the [Antenna
Setting] and then press ENTER ( ).
3. Use
I
/
i
to select a desired particular
satellite.
4. Select an item using
U
/
u
. If you know the
programmed [LNB Frequency], [22kHz
Tone], [DiSEqC], [LNB Power], [Transponder]
and [Motor], use
I
/
i
to select the desired.
If you select [DiSEqC 1.2], you can set Motor
Driving Mode, Motor Move and Set Limit,
and if you select [USALS], you can set the
longitude and latitude and use
u
to select
[Go to position]; then motor will move to
your selelected satellite as calculating its
position.
NOTE
If you use USALS, you should know lines of
longitude and latitude at your location.
5. Use
U
/
u
to select the [Save] and press
ENTER ( ) to display the [Saved List] menu.
NOTE
If there isn’t LNB Frequency what you want in [LNB
Frequency], input LNB Frequency with numerical
buttons.
6. Use
U
/
u
/
I
/
i
to select the [Go To Tuning]
and press ENTER ( ).