TROUBLESHOOTING 39 TROUBLESHOOTING The washer is equipped with an automatic error-monitoring system to detect and diagnose problems at an early stage. If the washer does not function properly or does not function at all, check the following before you call for service, Before Calling for Service Error Messages e The load is too sm: UNBALANCE ERROR | * Add additional items to allow the washer to balance the load. Heavy articles are mixed with lighter Items.
40 TROUBLESHOOTING dr Special drain feature DRAIN FEATURE » If the washer is paused during a cycle for more than 4 minutes, the cycle will be canceled and any water remaining in the tub will be drained. » This Is not an error code. It Indicates that the drain function Is operating. dE Lid is not closed properly. LID ERROR + Close the lid properly. + If the lid is closed and this error message is still displayed, call for service. o Lid is not locked properly. LID LOCK ERROR.
TROUBLESHOOTING 41 Moises Clicking Lid lock sounds when the lid locks or unlocks. * Normal operation Spraying or hissing Water spraying or circulating during the cycle * Normal operation already begun to operate Humming or Drain pump Is pumping water from the washer at mes during a cycle. Gurgling * Normal operation Water sloshing All quid in the balance ring around the pulsation helps the basket spin smoothly.
2 TROUBLESHOOTING Operation Water Leaking Hoses are not connected correctly. » Check hoses and connectors for leaks, cracks, and splits. * Check and tighten hose connections. House drain pipes are clogged. + The washer pumps out water very rapidly. Check for water backing up out of the drain pipe during drain. If water Is seen coming out of the drain, check for proper drain hose installation and check for restrictions In the drain. * Contact a plumber to repair drain pipe.
TROUBLESHOOTING 43 Incomplete or no dispensing of detergent Detergent compartments clogged from incorrect filling. * Make sure that detergent and additives are put Into the correct dispenser compartments. * For all detergent types, always make sure that the dispenser drawer is fully closed before the start of the cycle. Too much detergent used. * Make sure that the suggested amount of detergent is used according to the manufacturer's recommendations.
44 TROUBLESHOOTING Washer is not filling properly. It er is clogged. * Make sure that inlet filters on the fell valves are not clogged. Refer to Cleaning the Water Inlet Liters In MAINTENANCE. Inlet hoses may be kinked. » Check that Inlet hoses are not kinked or clogged. Energy efficiency = This Is a High-Efficiency (HE) washer. As a result, the water level settings for this washer may be different than for conventional washer.
TROUBLESHOOTING 45 Performance Wrinkling Washer Is not unloaded promptly. » Always remove Items from the washer as soon as the cycle Is complete. Washer is overloaded. * The washer can be fully loaded, but the tub should not be tightly packed with stems. The lld of the washer should close easily. Hot and cold water Inlet hoses are reversed. * Hot water rinse can set wrinkles In garments. Check the Inlet hose connectors. Staining Bleach or softener dispensed toc soon.