User manual
MICRO Hi-Fi SYSTEM ] USER GUIDE
11
Troubleshooting
Designs and specifications are subject to change without notice.
Symptom Cause Correction
Specifications
General
Net Weight 2.3kg
External dimensions (WxHxD) 146 x 238 x 251 mm
Tuner
FM Tuning Range 87.5 - 108.0 MHz or 65 - 74 MHz,
87.5 - 108.0 MHz
AM Tuning Range 522 - 1620 kHz or 520 - 1720 kHz
Amplifier
Output Power 5 W + 5 W
T.H.D 0.5 %
Frequency Response 60 - 20000 Hz
Signal-to-noise ratio 60 dB
CD
Frequency response 100 - 18000 Hz
Signal-to-noise ratio 55 dB
Dynamic range 50 dB
Cassette tape player
F.F/REW Time 120 sec (C-60)
Frequency Response 250 - 8000 Hz
Signal to Noise Ratio 40 dB
Channel Separation 30 dB (P/B)/30 dB (R/P)
Erase Ratio 50 dB (MTT-5511)
Speakers (XCS12F)
Type 1 Way 1 Speaker
Impedance 4 Ω
Frequency Response 100 - 18000 Hz
Sound Pressure Level 82 dB/W (1m)
Rated Input Power 5 W
Max. Input Power 10 W
Net Dimensions (WxHxD) 144 x 238 x 134 mm
Net Weight (1EA) 1.29 kg
No power.
No sound.
The unit does not
start playback.
The remote
control does not
work properly.
Unable to record.
• The power cord is disconnected.
• The power of the external source
equipment is turned off.
• The speaker cable is connected
to a wrong position.
• An unplayable disc is inserted.
• The disc is placed upside down.
• The disc is not placed within the
guide.
• The disc is dirty.
• The remote control is not pointed
at the remote sensor of the unit.
• The remote control is too far from
the unit.
• There is an obstacle in the path
of the remote control and the unit.
• The battery in the remote control
is exhausted.
• Record protect tabs are removed.
• Plug the power cord into the wall
outlet securely.
• Switch on the external source
equipment.
• Set the speaker cable to the cor-
rect position, then turn on the unit
again by pressing POWER.
• Insert a playable disc.
• Place the disc with the playback
side down.
• Place the disc on the disc tray
correctly inside the guide.
• Clean the disc.
• Point the remote control at the
remote sensor of the unit.
• Operate the remote control within
about 23 ft (7 m).
• Remove the obstacle.
• Replace the battery with new
one.
• Cover holes on back edge of tape
with tap.