Owner's Manual REFRIGERATOR Before connecting, operating or adjusting your refrigerator, please read this Owner’s manual carefully.
TABLE OF CONTENTS Description of parts and controls 1 Setting up and test run 4 Cleaning and Maintenance 6 Lamp Replacement 7 Repositioning the door hinge 8 This new refrigerator was manufactured with great care and according to latest techniques. We are confident that you will be fully satisfied with its performance and dependability. Before you start using your refrigerator, please read this booklet carefully.
DESCRIPTION OF PARTS AND CONTROLS 1. Ice cube tray Ice cubes are easy to remove from the tray. 2. Thermostat dial Regulates the operation of the motor and controls the temperature inside the refrigerator. 3. Shelves 4. Crisper & Glass lid For fruits and vegetables. 1 5. Evaporator The heart of the refrigerator. It evaporates the refrigerant fluid and thereby absorbs heat from the surrounding. Made of pure aluminum 6. Drip Tray 7. Bottle rack for bottles, cans or jars. 8.
DESCRIPTION OF PARTS AND CONTROLS 2 HOW TO MAKE AND REMOVE ICECUBES To make ice cubes, fill the cube trays with water to slightly below the rim and place it on the evaporator. If fast cubes are required, set the control to the maximum cooling position. (Be sure to rest the control to the desired position after cubes have been produced.) Ice cube tray is flexible. Twist tray to remove ice cubes. If the ice cube try is frozen hard to the evaporator surface, run a little water or lukewarm water.
DESCRIPTION OF PARTS AND CONTROLS 3 WHEN AND HOW TO DEEROST: For the most efficient operation of the refrigerator with After defrosting, remove drip tray and dispose of water. the minimum electric consumption, defrost the freezer whenever the layer of ice/frost on the walls of the Turn thermostat dial to desired position and refrigeration starts. evaporator reaches a quarter of an inch thick. Dial-setting defrosting To defrost, turn control to 0 (see fig.).
SETTING UP AND TEST RUN 4 WHERE TO PLACE YOUR REERIGERATOR •Select a place with strong, level floor. •Set up the refrigerator 5 inches away from the wall. • Since heat escapes from each side of the refrigerator, do not place it too close to the wall, or its performance will be affected (fig.1) •Avoid direct sunlight and heat. Light will discolor the enamel finish. When placed in direct sunlight, close to a stove or other source of herefrigerator will consume more electricity (fig.2.) • Avoid moisture.
SETTING UP AND TEST RUN 5 TEST RUN • Clean the refrigerator thoroughly; Wipe the outside with a soft cloth, the inside with a wet, lukewarm cloth. • Connect to receptacle for proper AC voltage: Keep the door open and turn thermostat dial to 0. • Set the thermostat dial on 6 or 7: Close the door and let motor run for 15-20 minutes. Then open the door. The evaporator should show some traces of frost. If the motor runs smoothly with just a soft hum, operation is satisfactory.
CLEANING AND MAINTENANCE The refrigeration does not require any maintenance, because the motor is completely sealed and self-lubricating. To clean the inside of the refrigerator, use a soft cloth with water, mild soap suds, or a mild detergent. Wash ice cube trays, drip tray, an shelf in a mild solution of detergent and dry with a soft towel. Stain on the outside can also be removed with a soft towel or a mild detergent.
LAMP REPLACEMENT 7 1.Unplug the power cord from the outlet. 2.Remove refrigerator shelves. 3.Remove the lamp by turning it counterclockwise as shown in the figure at right. 4.Assemble in reverse order of disassembly. Replacement bulb must be the same specification as original. IMPORTANT WARNINGS 7 ACCESSIBILITY OF SUPPLY PLUG The refrigerator-freezer should be so positioned that the supply plug is accessible for quick disconnection when accident happens.
REPOSITIONING THIE DOOR HINGE Your Freezer is designed with a reversible door so that is may open from either left or right. It is best to reposition the door hinge as necessary at the outset since it is inconvenient to do so later. To change the door hinge please refer to the diagram below and proceed as follows:--1.Remove all loose fittings from inside the appliance. 2.Carefully lay the appliance on its back on the original packing (You will need assistance to achieve this).
Warranty Certificate For offer a 24-month warranty for this apparatus During the 24-month warranty period, we will repair your apparatus at no cost to you or make available Spare parts to your dealer free , if this apparatus fails due to manufacturing or material defects. Further claims are excluded. We are not liable for damages due to acts of providence or damages occurring during transport. The buyer assumes shipping and packaging costs.
Warranty conditions for refrigerator 1. The warranty period begins on the purchase date and is valid for 24 months. Begin of warranty period is proven if, the buyer submits purchase receipt together with the warranty card, filled in and signed by the seller. The serial number of the product must agree with the number entered onto the warranty card. 2. During the warranty period, we will correct any defects at no cost to you, if it can be proven that these are attributed to manufacturing or material defects.