Operation Manual

DESCRIPTION OF PARTS AND CONTROLS 2
To make ice cubes, fill the cube trays with water to slightly
below the rim and place it on the evaporator. If fast cubes
are required, set the control to the maximum cooling
position. (Be sure to rest the control to the desired position
after cubes have been produced.)
Ice cube tray is flexible. Twist tray to remove ice cubes. If
the ice cube try is frozen hard to the evaporator surface, run
a little water or lukewarm water. To easily remove the ice
cubes, run water on the trays before twisting.
HOW TO MAKE AND REMOVE ICECUBES
Note: Do not use any sharp or metallic
instruments to remove ice, frost or ice cube trays from the
evaporator plate. A punctured evaporator will cause serious
problems and void the warranty.