Installation Manual

ENGLISH

INSTALLATION INSTRUCTIONS

Installer Setting - How to enter installer setting mode

INSTALLATION INSTRUCTIONS

1 With the JET COOL button pressed, press

the RESET button.

2 By using the TEMPERATURE SETTING

button, set function code and setting

value. (Please refer the Installer Setting

Code Table.)

3 Press the ON/OFF button toward the

indoor unit 1 time.

4 Reset the remote controller to use the

general operation mode.

CAUTION

Installer setting mode is to set the detail function of the remote controller.

If the installer setting mode is not set correctly, it can cause problems to the product, user

injury or property damage. This must be set by an certificated installer, and any installation

or change that is carried out by a non-certificated person should be responsible for the

results. In this case, free service cannot be provided.

Refer to the Installer Setting Code Table

on the next page.