Owner's Manual English, Spanish 02/01/2021 1836K

20 INSTALLATION
Leveling
Leveling and Door
Alignment
The refrigerator has two front leveling legs.
Adjust the legs to alter the tilt from front-to-
back or side-to side. If the refrigerator seems
unsteady, or the doors do not close easily,
adjust the refrigerator’s tilt using the
instructions below:
Both the left and right refrigerator doors have an
adjustable nut, located on the bottom hinge, to
raise and lower them to align properly.
If the space between the doors is uneven, follow
the instructions below to align the doors evenly:
Use the wrench (included with the owner’s manual)
to turn the nut in the door hinge to adjust the
height. Turn the nut to the right to raise the door
or to the left to lower it.
Turn the leveling leg to the left to raise that
side of the refrigerator or to the right to lower
it. It may take several turns of the leveling leg
to adjust the tilt of the refrigerator.
Open both doors and check to make sure that
they close easily. If the doors do not close
easily, tilt the refrigerator slightly more to the
rear by turning both leveling legs to the left. It
may take several more turns, and be sure to
turn both leveling legs the same amount.
1
2
• A are nut wrench works best, but an open-end
wrench will suce. Do not over-tighten.
• Parts, functions, and options vary by model. Your
model may not include all the Options, appears
with a dierent name and / or dierent position.
• After installing, plug the refrigerator’s power cord
into a 3-prong grounded outlet and push the
refrigerator into the nal position.
NOTE
• Do not overtighten the door adjustment screw.
The hinge pin can be pulled out and the
adjustable range of height is a maximum of 2 in.
(5 cm).
CAUTION
Position the Rrigerator
Turning on the Power
Start the Icemaker
• Arrange the coil of tubing so that it does not
vibrate against the back of the refrigerator or
against the wall. Push the refrigerator back to
the wall.
• If the water line is connected, set the icemaker
power switch to the ON position.
• The icemaker will not begin to operate until it
reaches its operating temperature of 15 °F (–9 °C)
or below. It will then begin operation
automati cally if the icemaker power switch is
in the ON (I) position.
Door Alignment
CAUTION
• Connect to a rated power outlet.
• Have a certied electrician check the wall
outlet and wiring for proper grounding.
• Do not damage or cut o the ground terminal
of the power plug.