Specification Sheet

Ensure proper ground
exists before use
Preferred
Method
LTG4715_
Gas Double Oven Slide-in
DIMENSIONS/CLEARANCES/WEIGHT
Cabinet Width (in) 30"
Overall Depth (in) - including handle 28 15/16"
Overall Height (in) - including backguard 37 7/8"
Overall Width (in) 29 7/8"
Oven Interior Dimensions (Upper) (in) (W x H x D) 24 13/16" x 9 1/4" x 20"
Oven Interior Dimensions (Lower) (in) (W x H x D) 24 13/16" x 14 1/4" x 20"
Height to Cooking Surface (in) 36"
Carton Dimensions (in) (W x H x D) 31 31/32" x 51" x 30 17/32"
POWER/RATINGS
Amp at 120V 8.3A
kW at 120V 996W
Requirements 120 VAC
LG COOKING
HOME APPLIANCES
QUICK INSTALL & CLEARANCES
For full installation directions/clearances please refer to
the corresponding User Manual and Installation Guide.
IMPORTANT
ELECTRICAL REQUIREMENTS
•
Shut off the range gas supply valve before removing the old range and leave it
off until the new hook-up has been completed..
•
Install a male 1/2” or 3/4” are union adapter to the NPT internal thread of the
manual shut-off valve, taking care to back-up the shut-off valve to keep it from
turning.
•
Install a male 1/2” are union adapter to the 1/2” NPT internal thread at the inlet
of the pressure regulator. Use a backup wrench on the pressure regulator tting to
prevent damage.
•
Check that the gas pressure regulator valve is in the open position.
CONNECTING THE RANGE TO GAS
Maximum
depth for
cabinets
above
coutertops
Front edge
of the range
side panel
forward from
cabinet
To
below
cooktop and
at the range
back
13"
0"
2
8
/
16
"
(6.3 cm)
30"
(76.2 cm)
30" (76.2 cm)
Minimum
15"
(38.1 cm)
36"
(91.4 cm)
0” To
cabinets
below
cooktop
and
at the
range
back
GAS PIPE AND ELECTRICAL OUTLET LOCATIONS
30"
(76.2 cm)
7
14
/
16
"
(20 cm)
5
9
/
10
"
(15 cm)
3
6
/
16
"
(8.5 cm)
3"
(7.6 cm)
17
15
/
16
"
(45.6 cm)
5
14
/
16
"
(15 cm)
6
11
/
16
"
(17 cm)
Depth with door closed
(includes door handle)
Height
37
7
/
8
"
(96.2 cm)
Depth with door open
40
9
/
16
"
(103 cm)
29
7
/
8
"
(75.7 cm)
28
15
/
16
"
(73.6 cm)
36"
(91.4 cm)
Lever’s open
position
Lever’s closed
position
•
Connect a exible metal appliance connector to the adapter on the range. Position
the range to permit connection at the shut-off valve.
•
When all connections have been made, be sure all range controls are in the OFF
position and the pressure regulator valve is open before turning on the main gas
supply valve. Gas leaks may occur in the system and create a hazard. Gas leaks
may not be detected by smell alone. Check all gas connection joints and ttings for
leaks with a non-corrosive leak detection uid, then wipe off.
•
Gas suppliers recommend you purchase and install a UL approved gas detector.
Install and use in accordance with the installation instructions.
CLEARANCES
DIMENSIONS
•
120 Volt, 60 Hz, properly grounded dedicated circuit protected by a 15 or 20 Amp
circuit breaker, or slow blow fuse.
•
If an external electrical source is utilized, the appliance, when installed, must be
electrically grounded in accordance with local codes or, in the absence of local
codes, with the National Electrical Code, ANSI/NFPA 70.
•
IMPORTANT: FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY
GROUNDED.
© 2018 LG Electronics USA, Inc. All rights reserved. "LG Life’s Good" is a registered trademark of LG Corp. All other product and brand names are trademarks or registered trademarks of their respective owners. Design, features and specifications are subject to
change without notice. Non-metric weights and measurements are approximate. Some features may require Internet access. Content and services may vary by product and are subject to change without notice. 8/22/18