Manual

-_ Beforecleaningthe washerinterior,unplugthe electrical powercordto avoidelectricalshockto
avoidelectricalshockhazards.
÷ Whendisposingof the appliance,cut offthe mainscable,anddestroytheplugDisablethedoor
lockto preventyoungchildrenbeingtrappedinside.
The water inlet filter
-"/E "error message will blink on the control panel when water does not enter the
detergent drawer.
- If your water isvery hard or contains traces of lime deposit, the water inlet filter may
become clogged.
It is therefore a good idea to clean it from time to time.
1. Turn off the
watertap.
3. Clean the
filter using a
hardbristle
brush.
2. Unscrewthe
water inlet
hose.
4. Tightenup
the inlet
hose.
The drain pump filter
-.'.teThedrainfiltercollectsthreadsandsmallobjectsleftinthelaundry.
Checkregularlythatthe filteriscleanto ensuresmoothrunningof yourmachine.
_,CAUTION Firstdrainusingthedrainhoseandthenopenthe pumpfilterto remove
whateveranythreadsorobjects.
Becarefulwhen drainingif the wateris hot.
÷ Allowthe waterto cool down beforecleaningthe drainpump,carryingout emergency
emptyingoropeningthe door inan emergency.
1. Open the lowercover
cap (_:) by usinga
coin.Turn the drain
plug (_) to pull out
the hose.
2. Unplugthedrain plug(_4),
allowingthe waterto flow out. At
thistime use a vessel to prevent
water flowingon to the floor. When
water does notflow anymore, turn
thepumpfilter (_) open tothe left.
3. Remove out anyforeign material
from the pumpfilter (Z_.).After
cleaning,turnthe pumpfilter (13)
clockwiseand insert the drain
plug ( 2.)tothe original place.
close the lowercover cap.