Manual

÷ Thiswashingmachineis equippedwith automaticsafetyfunctions which detectanddiagnosefaults
atan early stageandreactappropriately.
Whenthe machinedoesnotfunction properlyor doesnotfunctionat all,checkthe followingpoints
beforeyoucontactyour serviceprovider.
Rattling and
clanking noise
Thumping sound
Vibrating noise
Waterleaks.
Oversudsing
Water does not enter
washer or itenters
slowly
Water in the washer
does not drain or
drains slowly.
• Foreign objects such as coins or
safety pins maybe in drum or
pump.
• Heavywash loads may produce
a thumping sound. This is usually
normal
• Have all the transit bolts and
packing been removed?
• Are all the feet resting firmly on
the ground?
• Fill hoses or drain hose are loose
at tap or washer.
• House drain pipes are clogged.
• Water supply is not adequate in
area.
• Water supply tap is not
completely open.
• Water inlet hose(s) are kinked.
• The filter of the inlet hose(s) are
clogged.
• Drain hose is kinked or clogged.
• The drain filter is clogged.
Stop washer and check drum
and drain filter.
If noise continues after washer
is restarted, call your authorized
service centre.
If sound continues, washer is
probably out of balance. Stop and
redistribute wash load.
If not removed during
installation, refer to Installation guide
for removing transit bolts.
Wash load may be unevenly
distributed
in drum. Stop washer and
rearrange wash load.
Check and tighten hose connections.
Unclog drain pipe. Contact plumber
if necessary.
Too much detergent or unsuitable
detergent may cause excessive
foaming which may result inwater
leaks.
Check another tap in the house.
Fully open tap.
Straighten hose(s),
Check the filter of the inlet hose(s).
Clean and straighten the drain hose.
Clean the drain filter.