Instructions / Assembly

Before installation, read the following instructions carefully. Each Liberty pump is individually factory tested to insure proper

performance. Closely following these instructions will eliminate potential operating problems, assuring years of trouble-free service.

 Risk of electric shock. Always disconnect the pump from the power source before handling or making adjustments.

 The electrical connections and wiring for a pump installation should only be made by qualified personnel.

 This pump is supplied with a grounding conductor and grounding-type attachment plug. To reduce the risk of electric

shock, be certain that it is connected only to a properly grounded, grounding-type 15 Amp receptacle.

 Always wear rubber boots when water is on the floor and you must unplug the pump.

 DO NOT bypass grounding wires or remove ground prong from attachment plugs.

 DO NOT use an extension cord.

 This pump requires a separate, properly fused and grounded branch circuit. Make sure the power source is properly

sized for the voltage and amperage requirements of the pump, as noted on the nameplate.

 The electrical outlet shall be within the length limitations of the pump power cord, and at least 4 feet above floor level

to minimize possible hazards from flood conditions.

 The installation must be in accordance with the National Electric Code, Uniform Plumbing Code, International

Plumbing Code, as well as all applicable local codes and ordinances.

 Sump and sewage pumps often handle materials which could cause illness or disease. Wear adequate protective

clothing when working on a used pump or piping.

 Keep clear of suction and discharge openings. To prevent injury, never insert fingers into pump while it is plugged in.

 DO NOT use this product in applications where human contact with the pumped fluid is common (such as swimming

pools, fountains, etc.)

 NEVER dispose of materials such as paint thinner or other chemicals down drains, as they can chemically attack and

damage pump components, potentially causing product malfunction or failure.

 DO NOT drain water that exceeds 140F (60C) into basin.

 DO NOT modify the pump in any way.

 DO NOT lift or carry pump by power cord.

 DO NOT remove any tags from pump or cords.

 If pump is installed during construction before power is available, it must be protected from the environment to prevent

water from entering through the cord plug end, etc.

Fig. 1 – Typical Residential Installation

1. General Information and Safety Guidelines

2. Installation