Network Card User Manual

Opening a Web Connection
This section explains the Web interface in detail. From the Web, you can
monitor and control the UPS in which the card is installed. You can also
configure many settings of the card.
NOTE: To specify that the card communicates at either 10Mbit or
100Mbit, instead of it trying to auto-negotiate, you must use the Service
Terminal.
You access the Web Interface of the OpenComms Web Card by opening
a direct web browser. The card utilizes functionality of Microsoft Internet
Explorer 5.0 or higher. Whenever possible, you should use the latest
copy of IE.
1. Open your web browser software.
2. Enter the IP address or hostname of the card in the address line of
your browser.
The first page you will see every time you open a new Web connection to
the card is the Power Flow folder in the monitor tab. After your browser
connects, you will see a screen very similar to below:
Web