Design Guide 2013 Freestanding / Semi Built-In Models 24" and 48"
Welcome Liebherr's engineering excellence in Germany provides the largest selection of freezers, refrigerators and wine refrigerators worldwide. Liebherr appliances consistently specializes in the manufacturing of high quality freezers and refrigerators. With more than 300 basic models, we have the widest selection in the world. Liebherr appliances feature premium quality, numerous innovative product ideas and advanced design.
Introduction LIEBHERR WARRANTY PLAN FULL TWO YEAR WARRANTY - For two years from the date of original purchase, your Liebherr Warranty covers all parts and labor to repair or replace any part of the product which proves to be defective in materials or workmanship. FULL FIVE YEAR WARRANTY - For five years from the date of original purchase, your Liebherr Warranty covers all parts and labor to repair or replace any components that prove to be defective in materials or workmanship in the sealed system.
Contents General Remarks Safety Warnings I Electrical Requirements & Safety II IceMaker (if equipped) II Area Requirements III Safety Regulations III Freestanding/Semi Built In Models 24" and 48" Models: CS1200, CS13..
General Remarks I. Safety Warnings PLEASE READ AND FOLLOW THESE INSTRUCTIONS This design guide contains Warning and Caution statements. This information is important for safe and efficient installation. This design guide is not replacing the use and care manual which contains important information on how to use Liebherr appliances. Always read and follow all Warning and Caution statements! States a hazard that may cause serious injury or death if precautions are not followed.
General Remarks II. Electrical Requirements & Safety III. IceMaker (if equipped) A 115 Volt, 60 Hz, 15 Amp (20 Amp for side-by-side installation) fused electrical supply is required. Connect undercounter wine cabinet to a 115 VAC, 10 amp (15 Amp for side-by-side installations) circuit that is controlled by a circuit breaker or fuse. We recommend using a dedicated circuit for these appliances to prevent electrical overload.
General Remarks IV. Area Requirements V. Safety Regulations Verify the following: • Floors can support refrigerator’s weight plus approximately 1200 pounds (544 kg) of food weight. Not all Liebherr products are designed for 1200 pounds (544 kg) of food. Some units are smaller and total weights may vary. The appliance complies with UL250 and CAN/CSA C22.2 No.63-93 and is designed to cool, freeze, store food as well as make ice (if equipped). It is designed as a household appliance.
Freestanding/Semi Built In Models CS 1200, 1311, 1360 - SBS 26S1 24" and 48" Models: CS 1200, CS13.., SBS26S1 The unique design of Liebherr's freestanding models features fully stainless steel doors, and even stainless steel side walls - a perfect combination of design and functionality. New Swing Line doors with bevelled edges are a particularly elegant feature of this combination. Practical lever handles with integrated opening mechanisms make opening the appliance almost effortless.
Freestanding/Semi Built In Models °C Ventilation 9 7 5 3 1 -15 -18 -21 -25 -32 CS 1200, CS 1311, 1360 - SBS 26S1 CS 1200 Energy Star: qualified Energy consumption p. a.: 416 kWh Energy Supply: 115V/60Hz/350W Total capacity: 11.46 cu ft (325 L) Refrigerator: 8.15 cu ft (231 L) Freezer: 3.
Freestanding/Semi Built In Models CS 1200, 1311, 1360 - SBS 26S1 Unit Dimensions CS 1311 & CS 1360 & CS 1200 A. B. C. D. E. F. G. 2-7/32" (56.5 mm) CS13.. : 79-3/16" (2011 mm) CS12.. : 71-9/16" (1817 mm) 23-5/8" (600 mm) 25-3/16" (640 mm) 24-3/16" (614 mm) 24-13/16" (630 mm) 46-1/2" (1180 mm) NOTE Height dimension (B) represents the minimum height of the appliance(s) as measured from the floor to top of the door hinge cover. The height of the door hinge cover on top of the appliance is 15/32".
Freestanding/Semi Built In Models CS 1200, CS 1311, 1360 - SBS 26S1 Kitchen cabinet setup for the water filter To ensure optimum water quality for the production of ice cubes (only CS 1360) an external water filter module is available as an accessory. It should be installed near the appliance in the cabinet, for example, in the adapter cabinet above the appliance.
Freestanding/Semi Built In Models Cabinet Opening Dimensions CS1200, 1311, 1360 CS 1200, 1311, 1360 - SBS 26S1 The appliance can be integrated into the kitchen units. To adapt the appliance to the height of the row of kitchen units, a suitable top cupboard can be fitted above the appliance. Unit Venting DO NOT restrict the air flow. A cross-sectional air flow of at least 31" square (200cm²) must be provided.
Freestanding/Semi Built In Models CS 1200, CS 1311, 1360 - SBS 26S1 Cabinet Opening Dimensions SBS 26S1 The appliance can be integrated into the kitchen units. To adapt the appliance to the height of the row of kitchen units, a suitable top cupboard can be fitted above the appliance. The SBS 26S1 model can be installed in standard 24" (609mm) deep cabinets. You will only have to make sure that the door swing clearance is enough.
Freestanding/Semi Built In Models The cabinet opening height is 84" when using the decorative grille. The decorative grille is deliverable as accessory and is not required for proper operation of the appliance. All ventilation requirements are handled through the toe kick grille on the appliance and this decorative grille is intended to be used as a filler for pre-existing 84" openings. See chapter "Accessories for Liebherr Freestanding Semi Built In Appliances" page 9.
Freestanding/Semi Built In Models CS 1200, CS 1311, 1360 - SBS 26S1 Ventilation Requirements This type of cabinet must be carefully constructed using the correct dimensions and it must provide suitable ventilation to ensure proper appliance operation. Kitchen Cabinet Airflow The following ventilation dimensions must be observed: There must be a ventilation space at least 31 in.² (200 cm²) per appliance at the airflow inlet (1) and at the airflow outlet (2).
Freestanding/Semi Built In Models CS 1200, 1311, 1360 - SBS 26S1 Top Door Hinge Clearance CS 13.. - SBS 26S1 When installing CS units into a row of cabinets or wall units; use these dimensions to achieve a custom look with the cabinetry while providing the necessary clearance for the top door hinge. 9 NOTE It is good practice to leave some room for height adjustment of the appliance to accommodate uneven floors.
Freestanding/Semi Built In Models CS 1200, CS 1311, 1360 - SBS 26S1 Top Door Hinge Clearance CS1200 71-9/16” (1817 mm) 71 1/8” (1806 mm) 29-11/16” (754mm) 3/8” (10mm) 39-5/8” (1007 mm) 44 1-3/8” (35mm) 1-3/4” NOTE It is good practice to leave some room for height adjustment of the appliance to accommodate uneven floors.
Freestanding/Semi Built In Models CS 1200, 1311, 1360 - SBS 26S1 Door Swing Clearance CS 1200, CS 13..
Freestanding/Semi Built In Models CS 1200, CS 1311, 1360 - SBS 26S1 Accessories for Liebherr Freestanding - Semi Built In Appliances Kits may be necessary to complete this unit's installation or to apply it in a different manner than its original intent. If a kit is necessary, contact your Liebherr retailer or distributor. All installation materials for accessories are included with the kits.
Design Guide 2013
