Operating instructions

10
Switching the appliance on and off
Switching the appliance on
Press the On/Off button until the temperature display
lights up.
Switching the appliance off
Keep the On/Off button pressed for approx. 3 seconds so that the
temperature display goes out.
Safety lock
The lock is equipped with a safety
mechanism.
Locking the appliance
• Insert the key as shown by ar-
row 1.
• Turn the key 180°.
To unlock the appliance, the same
procedure must be repeated in
the same order.
Operating and control elements
1Temperature display
2Temperature setting buttons
3Audible warning On/Off button
4Child lock activated symbol
5On/Off button
6Fan On/Off button combination
7Fan On symbol
GKv 57
A = 1864 mm - 1896 mm
GKv 64
A = 2064 mm - 2096 mm
GKv 43
Appliance dimensions
Electrical connection
Only operate the appliance with alternating current (AC).
The permissible voltage and frequency are indicated on the type
plate. The position of the type plate is shown in the section entitled
Description of the appliance.
The socket must be properly earthed and protected by a fuse.
The tripping current of the fuse must be between 10 A and 16 A.
The socket must not be situated behind the appli-
ance and must be easily accessible.
Do not connect the appliance using an exten-
sion cable or extension socket.
Do not use stand-alone inverters (conversion
of direct current to alternating current/three-
phase current) or energy-saving plugs. Risk
of damage to the electronic control system!
Setting up
• Do not place the appliance in direct sunlight or near cookers,
radiators and similar sources of heat.
• The floor on which the appliance stands should be horizontal and
level. Compensate for uneven floors with the adjustable feet.
•
Do not cover ventilation openings
or grille.
• Standard EN 378 specifies that the room in
which you install your appliance must have
a volume of 1 m
3
per 8 g of R 600a refriger-
ant used in the appliance, so as to avoid the
formation of inflammable gas/air mixtures in
the room where the appliance is located in the event of a leak
in the refrigerant circuit. The quantity of refrigerant used in your
appliance is indicated on the type plate on the inside of the ap-
pliance.
• Always install the appliance directly against the wall.