Exercise Bike User Manual

Life Fitness Models 9500RHR / 9100R Recumbent Exercise Bike
Fitness Entertainment Kit Installation
(for use with Broadcast Vision Fitness Cinema and Fitness Cinema 900 and Cardio Theater Wireless and LCS Wireless
systems)
Tools Required: Phillips Screwdriver, Small Adjustable Wrench
Step 1
Release the COLLAR by carefully depressing the user left and right sides inward until the COLLAR TABS disengage from the
SHROUDS.
Step 2
Remove the seventeen screws securing the user right SHROUD and carefully remove the SHROUD from the frame.
NOTE: BE CAREFUL NOT TO DAMAGE THE SHROUD WHEN MANEUVERING IT
AROUND THE PEDAL AND CRANK SHAFT.
Step 3
Remove the nuts and washers from the ALTERNATOR TERMINALS “B” and “E”.
Place the red wire RING TERMINAL(large) of the FITNESS ENTERTAINMENT
CABLE ASSEMBLY over ALTERNATOR TERMINAL “B” and secure the connector
with the appropriate nut and washer. Place the orange wire RING TERMINAL of the
FITNESS ENTERTAINMENT CABLE ASSEMBLY over ALTERNATOR TERMINAL “E”
and secure the RING TERMINAL with the remaining nut and washer. Tighten nuts to
25 - 30 in. lbs.
NOTE: DO NOT REMOVE THE EXISTING RING TERMINALS FROM THE
ALTERNATOR STUDS.
NOTE: TO AVOID POTENTIAL DAMAGE, BE SURE THE RING TERMINALS OF
THE FITNESS ENTERTAINMENT CABLE ASSEMBLY FACE THE CENTER OF
THE ALTERNATOR.
Step 4
Route the FITNESS ENTERTAINMENT CABLE ASSEMBLY along the existing wire
cluster and secure it near the existing wire tie with a supplied wire tie.
NOTE: BE SURE TO LEAVE ADEQUATE STRAIN RELIEF OF THE
FITNESS ENTERTAINMENT CABLE ASSEMBLY AT THE ALTERNATOR.
Step 5
Route the FITNESS ENTERTAINMENT CABLE ASSEMBLY along the top of the USER
RIGHT BOTTOM FRAME MEMBER and secure with a supplied wire tie next to each
existing wire tie location. (Figure 3)
Step 6
Feed the FITNESS ENTERTAINMENT
CABLE ASSEMBLY out the bottom of the
bike behind the FRONT SHROUD
BRACKET.
Step 7
NOTE: WITH A SUPPLIED ALCOHOL WIPE, CLEAN THE SHROUD AT EACH CABLE
CLAMP LOCATION BEFORE MOUNTING THE CABLE CLAMPS.
Place one ADHESIVE BACKED CABLE CLAMP 1” down from the top ridge of the user
left shroud and 1/2” from the inner edge. Position the CABLE CLAMP with the opening
facing the inner edge of the user left shroud. (Figure 4)
Step 8
Place another ADHESIVE BACKED CABLE CLAMP at the bottom front edge of the
user left shroud. Position the clamp with the opening facing the outside of the bike.
Step 9
Place a third CABLE CLAMP on the underside of the user left shroud front as close to the frame as possible (approximately 1” from
the frame). Continue to route the FITNESS ENTERTAINMENT CABLE ASSEMBLY tight against the user left shroud inserting the
FITNESS ENTERTAINMENT CABLE ASSEMBLY into the three pre-attached cable clamps.
Step 10
Apply four CABLE CLAMPS to the front of the user left shroud in-line and between the two previously installed CABLE CLAMPS
alternating the direction of the cable clamp openings. Insert the FITNESS ENTERTAINMENT CABLE ASSEMBLY into the CABLE
CLAMPS.
Step 11
Reverse steps 1 and 3 to return all shroud parts to their proper positions. Tighten screws to 12 - 15 in. lbs.
TerminalB
TerminalE
Continued
Fi
g
ure 4
Cable Tie
User Right
Bottom Frame
Member
Terminal “B”
Terminal “E”
Cable Assembly
(Bundle Excess)
Cable Clamp
Cable
Assembly
Collar
1”
User Left
Shroud
Fi
g
ure 3