Operation Manual

15
6. Handlebar and Computer Installation
Remove two M8x15 Bolts (41) and two Ø20xØ8 Curve Washers (42) from the Front Post (5).
Remove bolts with the 5mm Allen Wrench provided.
Connect the Hand Pulse Sensor Wires (58) from the Handlebar (6) to the Extension Hand
Pulse Sensor Wires (99) from the Front Post (5). Tuck wires into the Front Post (5).
Attach the Handlebar (6) onto the Front Post (5) with two M8x15 Bolts (41) and two Ø20xØ8
Curve Washers (42) that were removed. Tighten bolts with the 5mm Allen Wrench
provided.
Remove four M5x12 Bolts (57) from the back of the Computer (56). Remove bolts with the
Multi Hex Tool with Phillips Screwdriver provided.
Connect the Extension Sensor Wire (67) and Extension Hand Pulse Sensor Wires (99) to
the wires that come from the Computer (56). Tuck wires into the Front Post (5). Attach
the Computer (56) onto the top end of the Front Post (5) with four M5x12 Bolts (57) that were
removed. Tighten bolts with the Multi Hex Tool with Phillips Screwdriver provided.
Multi Hex Tool with
Phillips Screwdriver
S8, S13, S14, S15
Tool:
Allen Wrench 5mm
5
57
42
41
99
67
6
56
99
99
58
5
58