Owner Manual

3
STEP 3: CLEAN IT UP!
Stay safe while hot tubbing! Follow these
directions to protect yourself and your hot tub.
1. Buy chemicals and test strips from your
local hot tub or pool store to help sanitize
your tub and balance your tub’s pH, total
alkalinity, and calcium hardness.
2. Get that jet pump going at high speed and
leave jets running for 15 minutes before
adding in your chemicals.
3. Break out the test strips to check your
levels. Based on the results, add chemicals
as needed until your water is balanced and
safe to soak in. Levels too high? Too low?
Check your Owner’s Manual for next steps.
YOUR HOT TUB INFO
Collect the following information and
keep it in a safe place.
Date Purchased:
Purchased From:
Spa Model:
Serial Number:
© 2021 Watkins Wellness, PN 63593 Rev. A
Rotomolded
(1 Pump)
Rotomolded
(2 Pumps)
Acrylic Hot Tub
(1 Pump)
HOT TUB TIP:
Don’t know which button starts your jets?
Find one of the buttons below on your
control panel!
Congratulations! Your tub is lled up,
your water is balanced, and the temp is
just right. Now comes the fun part.
Step in, relax, and unwind!
HOT TUB TIP:
Your hot tub temperature maintains
itself with a sensor, just like a
refrigerator. Keep your hot tub plugged
in and turned on with the cover secured,
so you can enjoy your hot tub whenever
you’re ready!
FINALLY, RELAX IT UP!
HOT TUB TIP:
Don’t forget to shock your tub weekly!
Add your sanitizer of choice (bromine or
chlorine - the granular kind) and potassium
monopersulfate (MPS) shock, making sure
that your high-speed pump is activated.
Run the jets for 15 minutes, with the cover off,
to circulate the water and clean every inch of
the tub.
RECOMMENDED RANGES:
Total Alkalinity: Between 80-120 PPM*
0 40 80 120 180 240
Calcium Hardness: Between 50-150 PPM
0 50 100 150 200 250
Sanitize: Between 3-5 PPM
1 2 3 4 5 6
pH Level: Between 7.2 and 7.8
6.2 6.8 7.2 7.8 8.4 9.0
*Parts Per Million