Full Product Manual

11
OPERATING INSTRUCTIONS
1. Turn the heater on or off by pressing the
Power button on the control panel (C) or by
pressing the ON/OFF button on the remote
control (B).
Once the power is off, heating elements
will stop working first. The fan will continue
working for up to 90 seconds to dispense
residual heat inside the heater. This is a
normal function.
1
C B
2. Select a heat setting by pressing the MODE
button on either the control panel (C) or the
remote control (B) to toggle between the
three heat settings.
Power for high mode is 1,500 W; low is 750
W, or 1,000 W (HT1086-HT1087) ECO mode
is an economic energy saving function. When
ECO mode is chosen, the heater will operate
to maintain a constant warm 68°F.
Note: The ECO LED light will only illuminate
when the ECO function is active and the
ambient room temperature falls below
68ºF / 20ºC.
2
HIGH LOW ECO
C
B
3. Set the temperature by pressing the arrows on
the control panel (C) or the remote control (B).
You can set the temperature on the heater
anywhere between 50°F and 90°F or between
10°C and 36°C. Once you have chosen the
desired temperature, the heater will remain
on until the room temperature increases to
the temperature on the digital display. The
heater will cycle on and off to maintain the
desired room temperature.
To view the ambient temperature press the
ambient temperature button on the control
panel.
Note: To switch between Fahrenheit and
Celsius, press and hold the ambient
temperature button on the control panel
(C) for 5 seconds. On the remote (B),
short press the ambient temperature
button to switch between Fahrenheit
and Celsius, long press for 3 seconds to
engage child lock.
3
C
B
C
B
OR