Full Product Manual

14
WALL MOUNTING
1. Using a phillips screw driver, while the unit
is unplugged and placed on a flat surface,
locate and remove the screws securing the
feet on the bottom of the heater.
1
2. Determine the best wall location for mounting
the unit.
Note: Choose a location close to an electrical
outlet. Measure the length of the units
power cord to ensure it will reach.
Recommended minimum hanging
height is 12” from the ground to the bot-
tom of the unit. Max hanging height is
36” from the ground to the bottom of the
unit.
If mounting the bracket to dry wall, use the
outside screw slots (See Diagram A) along
with the provided drywall anchors.
If mounting the bracket to a wooden stud,
use the Top Middle and Bottom Middle Screw
slots (Diagram B). If you choose this option,
you will need to use a screw with min 2”
length (not provided).
2
3. Mount unit onto the bracket by positioning the
wall bracket with the heater bracket until the
two pegs align. Then pull down gently to lock
into place.
3
REQUIRED TOOLS:
Phillips Screwdriver Standard Level
B
A