Full Product Manual

11
OPERATING INSTRUCTIONS
1. Turn the heater on or off by pressing the
Power button on the control panel (C) or by
pressing the ON/OFF button on the remote
control (B).
Once the power is off, heating elements
will stop working first. The fan will continue
working for up to 90 seconds to dispense
residual heat inside the heater. This is a
normal function.
1
C
POWER
B
2. Select a heat setting by pressing the HEAT
button on either the control panel (C) or the
remote control (B) to toggle between the
three heat settings.
Power for heat-up mode is 1,500 W; heat-
down is 750 W. ECO mode is an Economic
Energy Saving Function. When ECO mode is
chosen, the heater will operate to maintain a
constant warm 68°F
Note: The ECO LED light will only illuminate
when the ECO function is active and the
ambient room temperature falls below
68ºF / 20ºC.
2
HIGH LOWECO
C
B
3. Set the temperature by pressing the arrows
on the control panel (C) or the remote control
(B).
You can set the temperature on the heater
anywhere between 50°F and 90°F or between
10°C and 32°C. Once you have chosen the
desired temperature, the heater will remain
on until the room temperature increases to
the temperature on the digital display. The
heater will cycle on and off to maintain the
desired room temperature.
To view the ambient temperature press the
ambient temperature button on the control
panel.
Note: Press and hold the ambient temperature
button on the control panel (C) for 5
seconds to switch the digital display indi-
cator on the heater between Fahrenheit
and Celsius.
3
C
B
TEMP.
UP
C
TEMP.
DOWN
OR