User's Manual

18
1. Overview 2. Installation 3. Setup & Use 4. Troubleshooting
5. Warranty &
Specifications
1. Overview 2. Installation 3. Setup & Use 4. Troubleshooting
5. Warranty &
Specifications
19
1. CHARGE INDICATORS: The light
glows RED while the REDMIKE VC
is charging. When fully charged,
the light will glow GREEN. A
blinking RED light indicates that
no battery is sensed, (REDMIKE VC
Yellow Protective Tab may not have
been completely removed—see
page 5, item 4.) A blinking Green
LED means a non- Lightspeed
battery has been installed (possibly
an alkaline battery).
2. DC POWER PORT: Connect the
DC power cord here.
3. OPTIONAL CHARGING PORT:
Plug the charging cord for the
optional LT-71 or the REDMIKE
Share microphones here.
CRADLE CHARGER CONTROLS AND
CONNECTIONS
1
2
3
INFRARED SENSOR/RECEIVER (ISR)
CONNECTIONS
1. POWER INDICATOR: This light
will glow blue when the ISR is
receiving power from the CAT AV.
(There is a blue light in the center
of logo on the front side – add
image of this).
2. A/B IR INDICATORS: These lights
glow when the corresponding
microphone (set to channel A or
B) is turned on and transmitting.
A steady light indicates a strong
signal.
3. SENSOR OUT: Connect the Cat 5
sensor cable to this connection to
send audio from the microphones
to the CAT AV amplifier.
4. IR EXPANSION: Connect up to
three passive IR sensors (IR-SR70F)
to this connection for larger
classrooms. For more than one
additional sensor a 3-way coax
splitter is required (HS3).
1
2
3
4