User's Manual

24
1. Overview 2. Installation 3. Setup & Use 4. Troubleshooting
5. Warranty &
Specifications
25
1. Overview 2. Installation 3. Setup & Use 4. Troubleshooting
5. Warranty &
Specifications
2. Install the Amplifier Module and Video Converter
Install Video Converter at the
Projector
• Installthe18”VGA,18”RCA,and
3.5 mm to IR Emitter cables to the
Video Converter
• InstalltheCAT-5cablelabeled
Video to the video converter
• Connectthe18”VGAand18”
RCA cables to the source inputs on
the projector.
• LocatetheIRControlwindow
on the projector and stick the IR
Emitter next to the window.
• Usingthe2”Velcrostrip,stick
one side on a flat spot on top of
the projector and the other to the
bottom of the Video Converter.
Velcro the video converter to the
top of the projector.
• Pullthe50’Speakerwire(s)
through the hole in the
bottom of the wall box and
wire to the phoenix connector
for SPEAKER 1 (also Speaker 2
is installing 4 speakers)
• Connectthepowersupplyto
the power input jack on the
Amplifier.
• Runthepowercordtothe
nearest wall outlet
• Screwthewallboxtothewall
over the mud ring.
• InstalltheSwitchermodulein
the wall box and close the lid.
Secure the wall box lid with
the two screws provided.
ON/IN WALL (NO ENCLOSURE) CONT’D
Install Amplifier on the wall by the
switcher
• Markthescrew/wall-anchor
locations for the Amplifier
• Mark(withpainterstape)location
of CAT AVfour Amplifier Module
• MounttheAmplierModuleon
the wall
• Installtwo1-gangmudringsor
electrical boxes
• Pullcables
• Installonewalldécorplatewith
three RJ-45 connectors and One
walldécorplatewithtwosetsof
two binding posts
• ConnecttheAudioInputjackon
theAmpliertothewalldécor
plate connector marked Audio
using a short CAT-5 cable labeled
Audio
• ConnecttheISR1jackonthe
Ampliertothewalldécorplate
connector marked ISR 1 using a
short CAT-5 cable labeled ISR 1
• Connectthespeakerwirebetween
the Phoenix connector on the
Amplifier and the binding post
connectionsonthewalldécor
plate labeled Speaker 1
• Connectthepowersupplytothe
power input jack on the Amplifier.
• Runthepowercordtothenearest
wall outlet
• Labelbothendsofallcables
(see page 22)
• Mark(withpainterstape)
location of CAT AVfour
Modules
• Installthemudringsor
electrical boxes
• Pullcables
• Usetheshort(12”)CAT-
5 cable labeled Audio to
connect the switcher Audio
output jack to the audio input
jack on the Amplifier
• Pullthetwo50’CAT-5cables
labeled ISR and Video into
the bottom of the wall box
and connect the ISR cable
to the connector labeled
ISR 1 and the Video cable to
the Switcher Video output
connector.
1. Install System Wall Plates & I/O Switcher
ON WALL IN EQUIPMENT ENCLOSURE