User's Manual

26
1. Overview 2. Installation 3. Setup & Use 4. Troubleshooting
5. Warranty &
Specifications
27
1. Overview 2. Installation 3. Setup & Use 4. Troubleshooting
5. Warranty &
Specifications
1. Install System Wall Plates & I/O Switcher
2. Install the Amplifier Module and Video Converter
• ConnectthecablestotheAudio
and Video outputs on the Switcher
• Installthewalldécorplateonthe
Switcher Module using the screws
provided
• Installthewalldécorplatetothe
installed mud ring or electrical
box.
Install the Video ConverterModule
• Installthe18”VGA,18”RCA,and
3.5 mm to IR Emitter cables to the
Video Converter
• InstalltheCAT-5cablelabeled
Video to the video converter
• Connectthe18”VGAand18”
RCA cables to the source inputs on
the projector.
• LocatetheIRControlwindow
on the projector and stick the IR
Emitter next to the window.
• Usingthe2”Velcrostrip,stick
one side on a flat spot on top of
the projector and the other to the
bottom of the Video Converter.
Velcro the video converter to the
top of the projector.
• Labelbothendsofallcables(see
page 22)
• Mark(withpainterstape)location
of CAT AVfour’s Switcher Modules
• Installthe4-gangmudringor
electrical box
• PulltheCAT-5cablesmarked
Audio and Video
Install the Amplifier Module
• Preparetheequipmentenclosure
by assembling the front panel on
the enclosure
• CarefullyroutetheAudiocable
so the equipment box with the
amplifier can be set on the tile
bridge for the projector.
• InstalltheAmpliermoduleinthe
equipment enclosure using the
screws provided
• ConnecttheCAT-5cablelabeled
Audio to the Audio input jack on
the Amplifier
• ConnecttheISRCAT-5cableto
the IRS 1 jack on the Amplifier
• Pullthe50’Speakerwire(s)through
the hole in the side of the wall box
and wire to the phoenix connector
for SPEAKER 1 (also Speaker 2 is
installing 4 speakers)
• Securetheequipmentwallboxlid
with the two screws provided.
SWITCHER ON WALL & AMPLIFIER IN
ENCLOSURE ABOVE CEILING
To get started using the CAT AV two things need to happen:
1. The wireless selector needs to be synchronized with the system.
2. The system needs to learn the IR control codes for the classroom projector.
Lightspeed has preset the system with factory default values that should work
for a majority of classrooms. Access to these default settings are made available
to you through a series of setup procedures. All changes to factory settings are
accomplished using the Wireless Sector. These procedures are detailed in the
following paragraphs.
When installation is complete,
the Wireless Selector needs to be
synchronized with the system. This
process is called “Pairing”. Pair the
Wireless Selector by:
1. Remove the battery compartment
door
2. Find the push button along the left
side of the battery compartment
(see figure)
3. Push the pairing button located in
the battery compartment. A green
LED next to the button will light.
4. Find and push the pairing located
on the Amplifier Module. Hold this
pairing button in until the green
LED in the battery compartment
goes out (about 3 seconds).
The system and wireless selector are
now paired.
SECTION 3:
SET-UP & USE
1. GETTING STARTED
2. PAIRING THE WIRELESS SELECTOR TO
THE SYSTEM
Setup
Mode
Push to
Synchro-
nize with
System