User's Manual

28
1. Overview 2. Installation 3. Setup & Use 4. Troubleshooting
5. Warranty &
Specifications
29
1. Overview 2. Installation 3. Setup & Use 4. Troubleshooting
5. Warranty &
Specifications
3. SETUP MODE
The wireless selector provides access
to learn projector IR codes and
change factory default settings. The
set up functions are:
Microphone Volume
Equalizer Levels
Tone Levels
Auto Projector Shutdown Time
IR Learn Mode
Copy Setup, Return to Default
settings, Un-pairing
Entering Set Up Mode:
1. Remove the battery compartment
door
2. Find the slide switch above the
pairing button along the left side
of the battery compartment (see
figure)
3. Move the slide switch to its “UP”
position. The green LED next to
the projector ON button on the
front panel will blink indicating the
system is in the Set Up Mode.
Setup
Mode
Push to
Synchro-
nize with
System
4. SELECTING SET UP FUNCTION
Each of the set up functions is
represented by an LED located on the
wireless selector front panel as shown
in the following figure.
When first entering the setup mode,
LED 7 will glow red indicating the
Microphone volume setting function.
The up and down arrow buttons will
change the mode selection to the
desired function. Enter the desired
function by pushing the AV Mute
button. To change to select another
function, push the Mute button and
use the up & down arrow buttons to
select the new function.