User's Manual

34
1. Overview 2. Installation 3. Setup & Use 4. Troubleshooting
5. Warranty &
Specifications
35
1. Overview 2. Installation 3. Setup & Use 4. Troubleshooting
5. Warranty &
Specifications
Procedure:
1. Enter Set Up Mode
2. Make sure LED 4 is glowing green
or:
a. Push the Microphone Mute
button
b. Use the up & down arrow
buttons until LED 4 lights
3. Push the Mute AV Source button.
The default time setting (2 hours) is
shown on the Volume Level LEDs.
4. Use the up & down arrow buttons
to increase or decrease the
elapsed time setting.
5. Push the Microphone Mute button
to leave this set up mode and
select another function.
Replacing projector bulbs is expensive. To save energy and increase projector
bulb life, CAT AV will turn off the projector after a set elapsed time after the last
audio is processed by the system. The elapsed time can be set in 30 minute
increments from 30 minutes to 3 hours. A 30 second setting is provided for initial
testing of the Auto Power Down Mode.
8. AUTO POWER DOWN TIME SETTING
Picture of LED 4 lit & location of
AV Mute & Mute buttons
Picture of selector showing the
new meaning of the volume level
LEDS (function disabled, 30, 60,
90, 120, 150, 180 minutes & 30
seconds)
1. Enter Set Up Mode
2. Make sure LED 3 is glowing green
or:
a. Push the Microphone Mute
button
b. Use the up & down arrow
buttons until LED 3 lights
3. Push the Mute AV Source button.
The first LED next to the Select
button will light.
4. Learn projector ON Command:
Push button 7 or 8 to set the
system to listen for the IR
command.
5. Hold the emitter of the projector
remote control pointed at the IR
Learn window on the Amplifier
module
6. Push the power ON button on
the projector remote control. The
volume LEDs will blink when the
command is received.
7. Push button the Select button.
LED 2 by the Select button will
light.
8. Learn projector OFF Command:
Push button 7 or 8 to set the
system to listen for the IR
command.
9. Hold the emitter of the projector
remote control pointed at the IR
Learn window on the Amplifier
module
10. Push the power OFF button on
the projector remote control. The
volume LEDs will blink when the
command is received.
11. Push the Select button. LED 3 by
the Select button will light.
12. Learn projector VGA Input Select
Command: Push button 7 or 8 to
set the system to listen for the IR
command.
13. Hold the emitter of the projector
remote control pointed at the IR
Learn window on the Amplifier
module
9. IR LEARN MODE
Pix of projector remote close to
the Amplifier IR Learn Window