User's Manual

36
1. Overview 2. Installation 3. Setup & Use 4. Troubleshooting
5. Warranty &
Specifications
37
1. Overview 2. Installation 3. Setup & Use 4. Troubleshooting
5. Warranty &
Specifications
14. Push the VGA (or computer)
button on the projector remote
control. The volume LEDs will blink
when the command is received.
15. Push the Select button. LED 4 by
the Select button will light.
16. Learn projector Composite Select
Command: Push button 7 or 8 to
set the system to listen for the IR
command.
17. Hold the emitter of the projector
remote control pointed at the IR
Learn window on the Amplifier
module
18. Push the Video button on the
projector remote control. The
volume LEDs will blink when the
command is received.
19. Push the Select button. LEDs 1
and 2 by the Select button will
light.
20. Learn projector AV Video Mute
Command: Push button 7 or 8 to
set the system to listen for the IR
command.
21. Hold the emitter of the projector
remote control pointed at the IR
Learn window on the Amplifier
module
22. Push the Video Mute button on
the projector remote control. The
volume LEDs will blink when the
command is received.
23. Push the Microphone Mute button
to leave this set up mode and
select another function.
The projector IR codes have been
learned and stored in the CAT AV.
The Projectors remote control can
now be stored away.
9. IR LEARN MODE CONT’D
Need pictures to show steps.
Which steps? What should pics
be of?
To save valuable installation & setup time, CAT AV has a set-up copy mode. After
completing set-up of the first CAT AV system, the set-up information can be
down loaded into the wireless control then uploaded to new CAT AV systems as
long as the projector in each classroom is the same model.
1. Enter the Set Up Mode
2. Make sure LED 2 is glowing green
or:
a. Push the Mute button
b. Use the up & down arrow
buttons until LED 2 lights
3. Push the Mute AV Source button.
The first LED next to the Select
button will light.
4. Push button the down arrow
button to download the set-up
information to the wireless selector
5. Go to the next classroom
6. Push the pairing button located in
the battery compartment. A green
LED next to the button will light.
7. Find and push the pairing located
on the Amplifier Module of the
new system. Hold this pairing
button in until the green LED in
the battery compartment goes out
(about 3 seconds).
The system and wireless selector
are now paired.
8. Push the up arrow button (7) on
the wireless control. The set-up
information from the first system is
uploaded into the second system.
9. Repeat steps 5 through 8 for each
new system to be set up.
10. SET-UP COPY MODE
Picture of Selector battery
compartment and Amplifier
Module pairing button location.
Setup
Mode
Push to
Synchro-
nize with
System