User's Manual

38
1. Overview 2. Installation 3. Setup & Use 4. Troubleshooting
5. Warranty &
Specifications
39
1. Overview 2. Installation 3. Setup & Use 4. Troubleshooting
5. Warranty &
Specifications
Often the IT department will have an additional wireless selector to help
troubleshoot a possible problem with a classroom system. (CAT AV can have up
to 4 wireless selectors paired to the system at one time.) When the IT department
has found and corrected the problem and returns to the IT department, their
wireless selector should be unpaired to avoid any accidental system changes in
the classroom they just left.
1. Enter the Set Up Mode
2. Make sure LED 2 is glowing green
or:
a. Push the Mute button
b. Use the up & down arrow
buttons until LED 2 lights
3. Push the Mute AV Source button.
The first LED next to the Select
button will light.
4. Push the Select button to light LED
2 next to the Select button
5. Push the up or down arrow button
to un-pair the wireless selector.
The system and wireless selector
are now un-paired.
11. UN-PAIR WIRELESS SELECTOR MODE
Picture of wireless select with LED 2 lit
Picture of buttons used on wireless
selector
The CAT AV can be reset to its factory default settings using this procedure. If
you are unsure if the setup is correct or not, this mode allows you to return to
the beginning to start again. All setup functions are reset except learning the
projector IR commands.
1. Enter the Set Up Mode
2. Make sure LED 2 is glowing green
or:
a. Push the Mute button
b. Use the up & down arrow
buttons until LED 2 lights
3. Push the Mute AV Source button.
The first LED next to the Select
button will light.
4. Push the Select button until LED 3
next to the Select button is lit.
5. Push the up or down arrow button
to reset the system to factory
default settings.
12. RESET TO FACTORY DEFAULT SETTINGS
MODE
Picture of wireless select with
LED 2 lit
Picture of buttons used on
wireless selector