User's Manual

16
1. Overview 2. Installation 3. Setup & Use 4. Troubleshooting
5. Warranty &
Specifications
1. Overview 2. Installation 3. Setup & Use 4. Troubleshooting
5. Warranty &
Specifications
17
VIDEO CONVERTER CONNECTORS
1. VIDEO INPUT CONNECTOR:
An RJ-45 connector for accepting
video signals from the Switcher. A
CAT-5 cable is used to carry VGA
video, Composite video, power,
and IR control signals from the
Switcher to the Video Converter.
2. COMPOSITE VIDEO OUTPUT
CONNECTOR: An RCA connector
outputs composite video to be
carried to the projector composite
video input.
3. VGA VIDEO OUTPUT
CONNECTOR: A 15-pin Dsub
(female) connector outputs VGA
video signals to be carried to
the projector VGA input on the
projector.
4. IR CONTROL SIGNAL OUTPUT
CONNECTOR: A 3.5 mm (female)
connector output for connecting
an IR Emitter. Electrical control
codes are then converted by the IR
Emitter to infrared light for pick-
up by the IR receiver port on the
projector.
1. POWER BUTTON: Press this
button to turn the REDMIKE VC
ON, press again to turn it OFF
(mute).
2. POWER/LOW BATTERY
INDICATOR:
A BLUE light
indicates the REDMIKE VC is on
and fully charged. A RED light
indicates a charge is needed.
3. BATTERY COMPARTMENT: To
access the battery compartment,
slide the door downward. The
battery should only be replaced
by a Lightspeed AA rechargeable
sensing battery (part # BA-
NH2A27).
4. YELLOW PROTECTIVE TAB:
Slide the battery compartment
door open to remove this
disposable protective tab before
use. NOTE: do not attempt to
remove the tab without first
opening the compartment door, as
it may tear, leaving fragments.
5. AUDIO/MICROPHONE INPUT:
Use this input to plug in a laptop,
MP3 player or other audio
source to wirelessly transmit
audio to be played through the
system. Alternatively, an external
microphone can be connected.
6. CHANNEL SELECT SWITCH
(CH A/B): This switch allows
for selection between Channel
A or B. If you are using a single
microphone, we recommend using
Channel A.
7. VOLUME CONTROLS (UP –
DOWN)
8. CHARGER CONTACTS (+ -):
These contacts interface with the
charging tabs in the BC-RMCC
cradle charger for daily charging.
Simply place the REDMIKE VC in
the charger.
REDMIKE VC CONTROLS & CONNECTIONS
1
2
3
5
6
7
S
li
d
e
b
at
t
e
ry
d
o
o
r
o
p
e
n
R
e
m
o
v
e
t
a
b
b
e
fo
r
e
u
s
e
4
2
2
1
3
4