Instruction Manual

Spirit II User’s Manual Section 6: Maintenance &Troubleshooting
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
6-7
Error Codes
The following is a comprehensive list of error codes for the Spirit system. When the system
uses a Manual Gas Console, only the numeric error code is displayed. When an Automatic
Gas Console is used, the text description is also displayed.
Power Supply
Code
Short Description
Long Description
10121
ISC Door
ISC Door is open
10138
Stop Pressed (Off Button)
OFF Button on Plasma Console or Manual Gas
Console is pressed.
10140
Phase R
Transformer Secondary phase voltage is low
10150
Phase Y
Transformer Secondary phase voltage is low
10160
Phase B
Transformer Secondary phase voltage is low
10161
CON1
Main Contactor failed to open
10170
Coolant Level
Coolant Level is low
10180
Coolant Flow Low
Coolant flow is low
10190
Coolant Flow High
Coolant flow is high
10220
Coolant Temperature High
The coolant temperature is high
10290
GC Quiet
Lost CAN communication with Gas Console
10300
PC Quiet
Lost CAN communication with Plasma Console
10320
FCC Invalid
Final Cut Current invalid
10330
PAC Invalid
Pilot Arc Current invalid
10340
AH IHS Timeout
Arc Hold for Initial Height Sense has timed out
10350
PAT Not Established
Pilot Arc Current not established within 2 seconds
10360
TAC Not Established
Transferred Arc Current not established within 2
seconds
10370
Current Unbalanced
Current is not balanced between chopper
assemblies (275A and 400A systems)
10380
TAC Lost 1
Transferred Arc lost during TAC hold time
10390
TAC Lost 2
Transferred Arc lost during Upslope
10400
TAC Lost 3
Transferred Arc lost during Cutting
10410
TAC Lost 4
Transferred Arc lost during Downslope
10420
FCC Unreached
Did not achieve final cut current
10430
Output Over Current
Chopper has exceeded its maximum rated current
10432
Output Over Current TZ
Instantaneous Over Current detected
10440
Output Over Voltage
Maximum Cutting Voltage has been exceeded.
10450
Start Premature Removal
Start Signal removed prior to completion of upslope
10461
Chopper1 Temp
Chopper 1 maximum operating temperature
exceeded
10462
Chopper2 Temp
Chopper 2 maximum operating temperature
exceeded
10463
Chopper3 Temp
Chopper 3 maximum operating temperature
exceeded