Instruction Manual

Spirit II User’s Manual Section 3: Installation

This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to

non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.

3-15

Marking Plasma Gas Hose

1. Connect one end of the marking plasma gas hose to the marking plasma

outlet on the rear of the AGC.

2. Connect the other end of the marking plasma hose to the marking plasma

inlet on the 5-gang manifold.

Postflow Gas Hose

1. Connect one end of the postflow hose to the postflow outlet on the rear of the

AGC. Note that the postflow hose fittings have left hand threads.

2. Connect the other end of the postflow hose to the postflow inlet on the 5-gang

manifold.

Plasma Gas Hose

1. Connect on end of the plasma hose to the plasma outlet on the rear of the

AGC.

2. Connect the other end of the plasma hose to the plasma inlet on the 2-gang

manifold.

Shield Gas Hose

1. Connect one end of the shield hose to the shield outlet on the rear of the

AGC.

2. Connect the other end of the shield hose to the shield inlet on the 5-gang

manifold.

Preflow Gas Hose

1. Connect one end of the preflow hose to the preflow outlet on the rear of the

AGC. Note that the preflow hose fittings have left hand threads.

2. Connect the other end of the preflow hose to the preflow inlet on the 5-gang

manifold.

5-Gang Manifold Control Cable

1. Connect the 5-gang manifold control cable plug marked P15 to the 5-gang

manifold as shown.

2. Connect the 5-gang manifold control cable plug labeled P12 to the connector

labeled P12 on the rear of the power supply.

2-Gang Manifold Control Cable

1. Connect the 2-gang manifold control cable plug marked P18 to the 2-gang

manifold as shown.

2. Connect the 2-gang manifold control cable plug labeled P13 to the connector

labeled P13 on the rear of the power supply.