- LINDY Manual Access Switch Lite

5.5 Device Settings
5.5.1 Network
The Network Settings panel allows network related parameters to be changed. Each parameter
will be explained below. Once applied the new network settings will immediately come into
effect.
Note: The initial IP configuration is usually done directly at the host system using the
special procedure described in Section 3, page 7.
Changing the network settings of the IP ACCESS SWITCH LITE might result in losing
connection to it. In case you change the settings remotely make sure that all the values are
correct and
y
ou still have an o
p
tion to access the IP ACCESS SWITCH LITE.
IP auto configuration
With this option you can control if the IP ACCESS SWITCH LITE should obtain its network
settings from a DHCP or BOOTP server. For DHCP, select dhcp, and for BOOTP select bootp.
If you choose none then IP auto configuration is disabled.
IP address
IP address in the usual dot notation.
Subnet Mask
The net mask of the local network.
Gateway IP address
In case the IP ACCESS SWITCH LITE is accessible from networks other than the local one, this
IP address must be set to the local network router's IP address.
40