- LINDY Manual Access Switch Lite

5.5.7 Event Log
Important events like a login failure or a firmware update are logged to a selection of logging
destinations. Each of those events belongs to an event group, which can be activated
separately.
In the Event Log Settings you can choose how many log entries are shown on each page.
Furthermore, you can clear the log file here.
List logging enabled
The common way to log events is to use the internal log list of the IP ACCESS SWITCH LITE.
To show the log list, click on Event Log on the Maintenance page.
Since the IP ACCESS SWITCH LITE’s system memory is used to save all the information, the
maximum number of possible log list entries is restricted to 1000 events. Every entry that
exceeds this limit overrides the oldest one.
Note: If the reset button on the HTML front end is used to restart the IP ACCESS SWITCH
LITE all logging information is saved permanently and is available after the IP ACCESS
SWITCH LITE has been started. If the IP ACCESS SWITCH LITE loses power or a hard
reset is performed, all logging data will be lost. To avoid this, use one of the log methods
described below.
NFS Logging enabled
Defines an NFS server to write all logging data to a file that is located there. To write logging
data from multiple IP ACCESS SWITCH LITE units to only one NFS share, you have to define a
file name that is unique for each device. When you change the NFS settings and press Apply,
the NFS share will be mounted immediately. That means, the NFS share and the NFS server
must be filled with valid sources or you will get an error.
51