Owner's Manual

6062120 Rev 1.2
1
DOOR-GARD COMMAND AND CONTROL SERIES
212R, 212iLR, 212SE and 212iLSE Wiring Diagrams and Specifications
TECHNICAL NOTES
• To avoid ESD (Electro-Static Discharge) interfering with the operation of the
keypad, ground the housing to earth ground.
• The bi-color LED provided with the SE keypad illuminates red when the Lock-
Release relay is de-energized and green when the relay is de-energized.
• When mounting this unit outside, apply silicone to the area where the wires
enter the case. This helps prevent water from entering the case and condensing
on the circuit board. Do not silicone the cover plate because the unit will not
seal properly.
• Do not seal the drain holes at the bottom of the keypad housing. This allows air
to circulate and a place for condensation to drain.
• For use in extreme weather conditions, consult the factory for additional
methods of protecting your keypad.
• To speed installation of the SE keypad, holes have been spotted on the inside the
back housing for mounting to a wall or a single-gang electrical box.
• On SE keypad, holes have also been spotted inside the front housing for
additional LEDs (LEDs not included).
SPECIFICATIONS
Case Dimensions:
R Keypad: 3.75”W x 5.25”H x 2.50” D
SE Keypad: 3.00”W x 4.50”H x 1.55”D
Operating Voltage: 12-24V AC/DC (Auto-Adjusting)
Max Current Draw:
Main Relay Contacts (K1): 2A @ 12-24VAC/DC
Auxiliary Relay Contacts (K2, K3 & K4): 1A @ 12-24VAC/DC
Environment: Indoor or Outdoor
Temperature: 212R/212SE: -
31°F to 151°F (-35°C to 66°C)
212iLR/212iLSE: -4°F to 140°F (-20°C to 60°C)
WARRANTY
International Electronics, Inc. (IEI) warrants its products to be free from defects
in material and workmanship, when they have been installed in accordance with the
manufacturer’s instructions, and have not been modified or tampered with. IEI does
not assume any responsibility for damage or injury to person or property due to
improper care, storage, handling, abuse, misuse, normal wear and tear, or an act of
God.
IEI’s sole liability is limited to the repair or (at IEI’s option) the replacement of
the defective product or part when sent to IEI’s facility (freight and insurance
charges prepaid), after first obtaining IEI’s Return Merchandise Authorization.
IEI will not be liable to the purchaser or anyone else for incidental or
consequential damages arising from any defect in, or malfunction of, its products.
This warranty shall expire two years after shipping date for DOOR-GARD keypads.
Except as stated above, IEI makes no warranties, either express or implied, as to
any matter whatsoever, including, without limitation to, the condition of its products,
their merchantability, or fitness for any particular purpose.
Voltage
212R/SE 212iLR/iLSE
12VDC 50mA 84mA
24VDC 63mA 115mA
12VAC 86mA 128mA
24VAC 108mA 161mA