Operation Manual

Chapter 5
Advanced Configuration
18
8-Port 10/100/1000 Gigabit Switch with Webview
Address Mode Indicates whether the Switch is configured
with a Static or Dynamic IP address (configurable from
Setup - Network Settings tab).
Base MAC Address This is the MAC address of the
Switch.
System Information
Serial Number The serial number of the Switch is
displayed.
Model Name The model name of the Switch is
displayed.
Hardware version The current hardware version is
displayed.
Boot Version The current boot version is displayed.
Firmware Version The current software version is
displayed.
System Location The system location is displayed here
(configurable from Setup > Network Settings tab).
System Contact The contact person for this Switch
is displayed here (configurable from Setup > Network
Settings tab).
System Uptime This displays the amount of time that
has elapsed since the Switch was last reset.
Current Time The system time is displayed here
(configurable from Setup > Time tab).
PoE Information
Maximum Available Power Indicates the maximum
amount of power the device can supply.
System Operation Status Indicates whether the PoE
function is on or off.
Mainpower Consumption Displays how much power is
currently used.
Setup > Network Settings
Setup > Network Settings
The Network Settings screen allows you to assign DHCP
or static IP settings to interfaces and assign default
gateways.
Identification
System Name This field allows you to assign a system
name.
System Location This field is used for entering a
description of where the Switch is located, such as 3rd
floor.
System Contact Enter the administrative contact person
in this field.
System Object ID The system object identifier is
displayed here.
Base MAC Address This is the MAC address of the
Switch.
IP Configuration
Management VLAN This drop-down allows you to select
the Management VLAN.
IP Address Mode This drop-down allows you to select
Static or Dynamic IP address configuration.
Host Name Enter the DHCP Host Name here.
IP Address If using a static IP address, enter the IP address
here.
Subnet Mask Enter the subnet mask of the currently
configured IP address.
Default Gateway Enter the IP address of the Default
Gateway.