Operation Manual

Chapter 5
Advanced Configuration
19
8-Port 10/100/1000 Gigabit Switch with Webview
DNS Server Enter the primary DNS Server information.
Click the Save Settings button to save your changes or
click Cancel Changes to discard the information.
Setup > Time
The Time screen allows you to configure the time settings
for the Switch.
Setup > Time
Set Time
Use System Time When this option is selected, the local
hardware clock is utilized.
Use SNTP Time When this option is selected, the time is
synchronized to an SNTP (Simple Network Time Protocol)
server..
Local Time
Hours The hour can be entered here.
Minutes The minutes can be entered here.
Seconds The seconds can be entered here.
Month The month can be entered here.
Day The day can be entered here.
Year The year can be entered here.
Time Zone Enter the difference between Greenwich
Mean Time (GMT) and local time.
Daylight Saving
Daylight Saving Select Daylight Saving to enable it on
the Switch. If the Switch should use US daylight savings,
then select USA. If the Switch should use EU daylight
savings, then select European. If it should use another
kind of daylight savings, then select Custom and complete
the From and To fields.
Time Set Offset (1-1440) For non-US and European
countries, specify the amount of time for daylight savings.
The default is 60 minutes.
From If you selected Other for the Daylight Saving
setting, then enter the date and time when daylight
savings begins.
To If you selected Other for the Daylight Saving setting,
then enter the date and time when daylight savings ends.
Recurring If you selected Other for the Daylight Saving
setting and daylight savings has the same start and end
dates and times every year, then select Recurring.
From If you selected Recurring, then enter the date and
time when daylight savings begins.
To If you selected Recurring, then enter the date and time
when daylight savings ends.
SNTP Servers
Server1 Enter the primary SNTP server here.
Server2 Enter a secondary SNTP server here.
SNTP Polling Interval (60-86400) The value defined
here determines the amount of time (in seconds) before
the Switch polls the SNTP server. The default value is every
1024 seconds (approx. 17 minutes).
Click the Save Settings button to save your changes or
click Cancel Changes to discard the information.
Port Management > Port Settings
The Port Management > Port Settings screen shows you the
settings for each of the Switch’s ports.
Port The number of the port. To use an SFP module, click
on the Detail button of the appropriate port (G1, G2).
Description Displays a brief description of the port (can
be entered by clicking on the Detail button).
Administrative Status The port can be taken offline by
selecting the Down option. When Up is selected, the port
can be accessed normally.
Link Status Up indicates a port has an active connection,
Down indicates there is no active connection or the port
has been taken offline by an Administrator.