User Guide

Chapter 5
Advanced Configuration
23
WebView Switches
Setup > Green Ethernet
The Green Ethernet Configuration screen allows you to
enable energy-efficient Ethernet (EEE). EEE optimizes
power consumption by monitoring both port and
system power requirements, while minimizing energy
consumption. Green Ethernet ensures that the network
operation is not comprimised, while at the same time
maintaining a Green network.
This feature has been added to version 1.1 of SRW2048
and to version 1.3 of SRW2024 and SRW2016.
Setup > Green Ethernet
Energy Saving Mode Indicates if Green Ethernet is
enabled on the device. The possible field values are:
Enable • Enables Green Ethernet on the device. This is
the default value.
Disable • Disables Green Ethernet on the device.
Energy Saving Indicates the amount of energy conserved
by enabling Green Ethernet.
Port Management > Port Settings
The Port Settings screen shows you the settings for each of
the Switch’s ports.
Port Management > Port Settings
Port The port number. To use an SFP module, click the
Detail button of the appropriate port (G1, G2).
Description A brief description of the port. To enter or
modify the description, click the Detail button.
Administrative Status The port’s administrative status.
To take the port offline, select the Down option. To allow
normal access to the port, select Up.
Link Status The port’s operational status. Up indicates a
port has an active connection. Down indicates there is no
active connection or the port has been taken offline by an
Administrator.
Speed The port’s configured rate in Mbps. The speed can
be configured only when auto-negotiation is disabled on
that port.
Duplex The port’s current duplex mode: Full
(transmission occurs in both directions simultaneously) or
Half (transmission occurs in only one direction at a time).
This mode can be configured only when auto-negotiation
is disabled and port speed is set to 10Mbps or 100Mbps.
It cannot be configured on Link Aggregation Groups
(LAGs).
MDI/MIDX The MDI/MDIX status of the port. The MDI
setting is used if the port is connected to an end station.
The MDIX setting is used if the port is connected to a hub
or another switch.
Flow Control The type of flow control currently in use. It
is active when the port uses the Full Duplex Mode.
Type The port type.
LAG The Link Aggregated Group (LAG) to which the port
belongs, if the port is a LAG member.