User Guide

Chapter 5
Advanced Configuration
56
WebView Switches
User Name Displays the user name.
Password Specifies the new password. The password is
not displayed. As it entered an “*” corresponding to each
character is displayed in the field. The range is 1–159
characters.
Confirm Password Confirms the new password. The
password entered into this field must be exactly the same
as the password entered in the Password field.
Use the Add to List button to add the user configuration
to the Local User’s Table.
Admin > Jumbo Frames
Admin > Jumbo Frames
Jumbo Frames This option enables the transportation of
identical data in fewer frames. This ensures less overhead,
lower processing time and fewer interruptions.
NOTE: The Jumbo Frames tab is not an available
option on the SRW224G4 and SRW248G4
Switches.
Admin > Static Address
A static address can be assigned to a specific interface on
this switch. Static addresses are bound to the assigned
interface and cannot be moved. When a static address is
seen on another interface, the address will be ignored and
will not be written to the address table.
Admin > Static Address
Interface Displays the interface to which the entry
refers:
Port • The specific port number to which the forwarding
database parameters refer.
LAG • The specific LAG number to which the forwarding
database parameters refer.
MAC Address Displays the MAC address to which the
entry refers.
VLAN ID Displays the VLAN ID number to which the entry
refers.
VLAN Name Displays the VLAN name to which the entry
refers.
Status Displays how the entry was created. The possible
field values are:
Permanent • The MAC address is permanent.
Delete on Reset • The MAC address is deleted when
the device is reset.
Delete on Timeout • The MAC address is deleted when
a timeout occurs.
Secure • The MAC Address is defined for locked ports.
Query
Port Specifies the interface for which the table is queried.
There are two interface types from which to select.
Port • The specific port number.
LAG • The specific LAG number.