Installation Guide

page 9
HI button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
OFF button - turns fan OFF
button - controls LIGHT function; turns light
ON/OFF when tapped quickly. Pressing and
holding button down for more than 0.7 seconds
converts it into a dimmer. Auto resume
capability keeps light at same brightness level
as the last time it was turned off.
11. Remote Control Operation.
12. Testing Your Fan.
It is recommended that you test fan before
finalizing installation. Test fan speeds with the
different fan speed buttons on remote control.
Test the light ON/OFF function with the
button on the remote control. Test dimmer
function by holding down the button for
more than 2 seconds. If the remote control
operates all of the functions of the fan and
light, battery has been installed correctly
(diagram 1). If fan and/or light does not
function, please refer to "Troubleshooting"
section to solve any issues before contacting
Customer Service.
Turn fan completely off before moving the
reverse switch (located on top of motor
housing). Set reverse switch to recirculate air
depending on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either
completely to the LEFT or completely to the
RIGHT for fan to function. If the reverse switch
is set in the middle position (diagram 4), fan
will not operate.
diagram 2 diagram 3 diagram 4
diagram 1
reverse switch