Installation Guide

page 6
7. Canopy Assembly.
Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both
screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.
canopy cover
screw
hanging bracket
screw
canopy
8. Blade Assembly.
motor
housing
blade
decorative
nuts
blade arm
blade attachment
screws and washers
lock washer and
blade arm screw
Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers and 15 decorative nuts in one of the
hardware packs. Place blade arm on TOPSIDE
(ridged side) of blade, aligning holes in blade
arm with holes in blade. Insert a decorative nut
into center hole from UNDERSIDE (flatside) of
blade making sure to completely insert
decorative nut so that the blade arm can be
attached correctly. Insert a blade attachment
screw (along with washer) from TOPSIDE of
blade but do not tighten completely. Repeat
for remaining holes in blade and then tighten
all 3 screws securely with a Phillips screwdriver.
Repeat procedure for remaining blades.
Remove blade arm screws and lock washers
from underside of fan motor and set aside.
[WARNING: Do NOT remove the 4 screws
located on the outer rim of the underside of
the motor housing--doing so or any attempt at
doing so will void the warranty.] Align blade
arm holes with motor screw holes and attach
blade arm with lock washers and blade arm
screws. Before securing screws permanently,
repeat this procedure with remaining blade
arms. Secure all screws.
Note: Tighten blade arm screws twice a year.