Installation Instructions

page 6
7. Canopy Assembly.
Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both
screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.
canopy cover
screw
hanging bracket
screw
canopy
8. Blade Assembly.
motor
housing
blade
decorative
nuts
blade arm
blade attachment
screws and washers
lock washer and
blade arm screw
WARNING: To reduce the risk of serious bodily
injury, DO NOT use power tools to assemble the
blades. If overtightened, blades may crack and
break.
Time Saver: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers
and 15 decorative nuts in one of the hardware
packs. Place blade arm on TOPSIDE (ridged side)
of blade, aligning holes in blade arm with holes
in blade. Insert a decorative nut into center hole
from UNDERSIDE (flatside) of blade making sure
to completely insert decorative nut so that the
blade arm can be attached correctly. Insert a
blade attachment screw (along with washer)
from TOPSIDE of blade but do not tighten
completely. Repeat for remaining holes in blade
and then tighten all 3 screws securely with a
Phillips screwdriver. Repeat procedure for
remaining blades.
Remove blade arm screws and lock washers from
underside of fan motor and set aside. [WARNING:
Do NOT remove the 4 screws located on the
outer rim of the underside of the motor
housing--doing so or any attempt at doing so
will void the warranty.] Align blade arm holes
with motor screw holes and attach blade arm
with lock washers and blade arm screws. Before
securing screws permanently, repeat this
procedure with remaining blade arms. Secure all
screws.
Note: Tighten blade arm screws twice a year.