Installation Guide

page 5
5. Fan Assembly (with downrod). (cont. )
With the hanging bracket secured to the outlet
box and able to support the fan you are now ready
to hang your fan. Grab the fan firmly with two
hands. Slide downrod through opening in hanging
bracket and let hanging ball rest on the hanging
bracket. Turn the hanging ball slot until it lines up
with the hanging bracket tab.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you
once you are set on the ladder.
Continue to "Wiring" section for wiring diagram.
hanging ball slot
hanging bracket tab
6. Fan Assembly (flushmount).
canopy
canopy cover
motor housing
canopy
hanging bracket tab
Remove canopy cover and set aside to reveal
6 holes. Notice that 3 of the holes are larger
than the others.
Note: The yoke cover is not used with this
type of installation.
If there are only 3 screws in top of motor
housing, please proceed to next paragraph. If
there are 6 screws in top of motor housing,
remove every other screw and lock washer.
Thread wiring through canopy. Place canopy
over yoke, aligning larger holes in canopy
with the 3 existing screws in top of motor
housing. Insert the 3 screws and 3 lock
washers that had been removed (if there
were only 3 screws located in top of motor
housing, these screws/lock washers will be
located in one of the hardware packs) into
the remaining holes. Securely tighten these
screws.
To prepare the fan for wiring, hang fan onto
hanging bracket by sliding the canopy over
the hanging bracket tab. (Use one of the
non-slotted holes on the rim of the canopy
to do so.)
motor housing
yoke
canopy