Installation Guide

page 6
canopy
hanging bracket
7. Wiring.
black
black
white
white
blue
black supply wire
ground
(green
or bare)
white supply wire
Important: Be sure outlet box is properly grounded
or that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to below, please use a
qualified electrician.
When downrod is secured in place on the
hanging bracket, electrical wiring can be
made as follows:
Connect BLACK and BLUE wire from fan to
BLACK wire from ceiling with wire connector
provided.
Connect WHITE wire from fan to WHITE wire
from ceiling with wire connector provided.
Connect all GROUND (GREEN) wires together
from fan to BARE/GREEN wire from ceiling with
wire connector provided.
If you intend to control the fan light with a
separate light switch connect BLUE wire from fan
to the BLACK supply from the independent
switch.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
This fan is remote control adaptable (remote control
sold separately).
*
from ceiling
from fan
ground
(green or bare)
8. Canopy Assembly.
Temporarily lift canopy to hanging bracket to
determine which 2 screws in hanging
bracket align with slotted holes in canopy
and partially loosen these 2 screws. Remove
the other 2 screws. Now, lift canopy to
hanging bracket again, aligning slotted holes
in canopy with loosened screws in hanging
bracket. Twist canopy to lock. Re-insert the 2
screws that were previously removed.
Tighten all screws securely.